Rockwell Automation Publication IASIMP-QS005H-EN-P - April 2016 27
Chapter 2
Hardware Selection and Safety Wiring Layout
Introduction
In this chapter, you will create a bill of materials and access CAD drawings from the safety accelerator toolkit to lay out
your system wiring. You will also use two worksheets to document your devices in preparation for developing application
logic.
Before You Begin
Complete a risk assessment and safety system specification as recommended in Chapter 1.
Make sure that you have installed the required software and have access to the Internet if you are not using the Safety
Accelerator Toolkit DVD.
What You Need
• Personal computer with internet access for downloading software and files
• AutoCAD program to open the .dwg files or Adobe Acrobat Reader software to open .pdf files.
• Safety Accelerator Toolkit, DVD SAFETY-CL002, or visit the Integrated Architecture® Tools and Resources
website at http://www.ab.com/go/iatools
to download toolkit files
• Safety Products catalog, available at http://www.ab.com/catalogs/
•Microsoft Excel software
TIP Use AutoCAD Electrical to take advantage of advanced features.
To Next Page
Loading...