Rockwell Automation Publication IASIMP-QS005H-EN-P - April 2016 31
Hardware Selection and Safety Wiring Layout Chapter 2
3. Make a copy of the Safety_Zone_Configuration.xls file for each safety zone in your application and name them
using the ZoneName, for example Zone1.xls.
4. Open your newly created Safety Zone Configuration worksheet and enter a Zone Name.
For this example, we entered Zone1. The ZoneName will be inserted in many of the Zone Tags listed in the
worksheet. You will use the tag names in this worksheet in your application logic, developed in Chapter
3 for
GuardLogix Controllers, and Chapter
4 for SmartGuard 600 controllers.
5. Type a Safety Module Name for each module used in the Safety Zone and save the file.
For this example, we entered CellGuard1 and CellGuard2 for Safety Module 1 and 2, respectively.
To Next Page
Loading...