Rockwell Automation Publication 750-TG100B-EN-P - June 2019 291
Chapter 11
Start Up After Repairs
This chapter provides detailed instructions for starting up a regenerative drive,
regenerative bus supply, and common bus inverter after you have completed
repairs and before power has been applied.
Before You Apply Power to
the Drive
Before you place a drive, bus supply and common bus inverter back into
operation, complete the appropriate instructions for your frame size and product.
• Instructions for frames 5 and 6 begin on page 292
.
• Instructions for frames 7…15 begin on page 294
.
Topic Page
Before You Apply Power to the Drive 291
No-load DC Bus Voltage and Output Current Measurements 298
To Next Page
Loading...
