Rohde & Schwarz CMW500 - Page 226

Command Reference - Base Software
R&S
®
CMW500
210User Manual 1173.9463.02 ─ 06
Firmware/Software: V2.0.10
TRACe:REMote:MODE:FILE<inst>:FORMat <Format>
Specifies the format of the target file for tracing of the remote interface for the specified
sub-instrument. The trace can be stored as ASCII file or as XML file.
Suffix:
<inst>
.
1..2
Selects the sub-instrument
Parameters:
<Format> ASCii | XML
Default value: XML
Example:
TRACe:REMote:MODE:FILE1:FORMat XML
Select XML as file format for sub-instrument 1.
Firmware/Software: V2.0.10
TRACe:REMote:MODE:FILE<inst>:NAME '<FilePath>'
Specify path and name of the target file for tracing of the remote interface. For different
sub-instruments specify different files.
If you specify a new target file while tracing, the old target file is closed, the new file is
created and tracing is continued with the new file.
Suffix:
<inst>
.
1..2
Selects the sub-instrument
Parameters:
'<FilePath>' String parameter specifying path and name of the file
Default values: "@LOG\RemoteTrace-Inst0.xml" and "@LOG
\RemoteTrace-Inst1.xml"
Example:
TRACe:REMote:MODE:FILE1:NAME "@LOG\trace1.xml"
Specifies the file trace1.xml in the log directory as target file for
tracing (sub-instrument 1).
Firmware/Software: V2.0.10
TRACe:REMote:MODE:FILE<inst>:SIZE <FileSize>
Specifies the maximum size of the trace file in bytes.
Suffix:
<inst>
.
1..2
Selects the sub-instrument
Instrument-Control Commands