Rohde & Schwarz CMW500 - Page 258

Command Reference - Base Software
R&S
®
CMW500
242User Manual 1173.9463.02 ─ 06
6.3.10.3 Installed Software and Device ID
The following commands provide information about the installed software, hardware,
licenses and the device ID. The "Setup" dialog provides this information in sections
"License Keys" and "SW/HW-Equipment".
SYSTem:BASE:OPTion:LIST?........................................................................................242
SYSTem:BASE:OPTion:VERSion?..................................................................................243
SYSTem:DEVice:ID?......................................................................................................243
SYSTem:BASE:OPTion:LIST? [<OptionType>[, <Validity>]]
Returns a list of installed software options (licenses), hardware options, software pack-
ages and firmware applications.
The list can be filtered using the described parameters. If this results in an empty list, a
"0" is returned.
The meaning of the filter <Validity> depends on the <OptionType> as follows:
●
A software option is valid if there is an active license key for it. The value "FUNCtional"
is not relevant.
●
A hardware option is functional if the corresponding hardware and all its components
can be used (no defect detected). The value "VALid" is not relevant.
●
A firmware application is functional if the required hardware, software and license
keys are available and functional. The value "VALid" is not relevant.
●
For software packages the filter has no effect.
Parameters:
<OptionType> SWOPtion | HWOPtion | SWPackage | FWA | ALL
List only software options, hardware options, software packages
or firmware applications. By default or if ALL is selected, all types
are listed.
<Validity> FUNCtional | VALid | ALL
List only functional entries or only valid entries. By default or if
ALL is selected, the list is not filtered according to the validity.
Example:
SYSTem:BASE:OPTion:LIST?
Returns an unfiltered list.
SYSTem:BASE:OPTion:LIST? SWOPtion, VALid
Returns all valid software options.
SYSTem:BASE:OPTion:LIST? FWA, FUNCtional
Returns all functional firmware applications.
Usage: Query only
Firmware/Software: V1.0.10.1
V2.0.10: Query parameters <OptionType> and <Validity> added
Instrument-Control Commands