Rohde & Schwarz CMW500 - Page 280

Command Reference - Base Software
R&S
®
CMW500
264User Manual 1173.9463.02 ─ 06
Firmware/Software: V2.0.10
STATus:OPERation:BIT<n>:CONDition?
STATus:OPERation:BIT<n>[:EVENt]?
Returns bit no. <n> of the CONDition or EVENt part of the STATus:OPERation register,
see also Structure of an SCPI Status Register. To return the entire parts see STATus:
OPERation:CONDition? and STATus:OPERation[:EVENt]?.
Suffix:
<n>
.
8 to 12
Number of the bit
Return values:
<BitValue> 0 | 1
Example:
STAT:OPER:BIT9:COND?
Query bit no. 9 of the CONDition part of the STATus:OPERation
register.
Usage: Query only
Firmware/Software: V1.0.4.11
STATus:OPERation:BIT<n>:ENABle <BitValue>
STATus:OPERation:BIT<n>:NTRansition <BitValue>
STATus:OPERation:BIT<n>:PTRansition <BitValue>
Sets bit no. <n> of the ENABle, NTRansition or PTRansition part of the STATus:OPER-
ation register, see also Structure of an SCPI Status Register. To set the entire parts see
STATus:OPERation:ENABle, STATus:OPERation:NTRansition and STATus:
OPERation:PTRansition.
Suffix:
<n>
.
8 to 12
Number of the bit
Parameters:
<BitValue> 0 | 1
Example:
STAT:OPER:BIT9:ENAB 1
Set bit no. 9 of the ENABle part of the STATus:OPERation regis-
ter.
Firmware/Software: V1.0.4.11
6.3.13.3 STATus:OPERation (Extended Commands)
The commands listed in this section serve the same purpose as the elementary com-
mands, see chapter 6.3.13.2, "STATus:OPERation (Elementary Commands)",
on page 256.
Instrument-Control Commands