Roland INTEGRA-7

SuperNATURAL Synth Tone (SN-S) – AMP tab
35
Parameter Value Explanation
FILTER Slope -12, -24 [dB]
This button selects the slope (steepness) of the lter.
For the LPF
-24 dB
Level
FrequencyCuto
frequency
-12 dB
FILTER Cuto 0–127 Species the cuto frequency.
FILTER Cuto KF -100–+100
Here’s how you can make the lter cuto frequency to vary according to the key you play.
C4C3C2 C5 C6
0
+50
+100
-50
-100
0
-2
-1
+2
+1
Cuto frequency
(octave)
High
Key
Value
Low
FILTER Env V-Sens -63–+63
Here’s how you can make the lter envelope depth vary according to the strength with which you
play the key.
FILTER Resonance 0–127 Resonance emphasizes the sound in the region of the lter cuto frequency.
FILTER Env Attack 0–127
This species the time from the
moment you press the key until
the cuto frequency reaches its
highest (or lowest) point.
Cuto
frequency
Time
Key-o
DEPTH
Key-on
FILTER Env Decay 0–127
This species the time from when
the cuto frequency reaches its
highest (or lowest) point, until it
decays to the sustain level.
FILTER Env Sustain 0–127
This species the cuto frequency
that will be maintained from
when the decay time has elapsed
until you release the key.
FILTER Env Release 0–127
This species the time from
when you release the key until
the cuto frequency reaches its
minimum value.
FILTER Env Depth -63–+63
This species the direction
and depth to which the cuto
frequency will change.
HPF Cuto 0–127
Species the cuto frequency of an independent -6 dB high-pass lter.
BYPASS, LPF, HPF,
BPF, PKG
-6 dB HPF
AMP tab
AMP Level 0–127 Partial volume.
AMP Level V-Sens -63–+63
Here’s how you can make the volume vary according to the strength with which you play the
keyboard.
AMP Pan L64–63R Here’s how to change the stereo position of the partial.