Roland INTEGRA-7

SuperNATURAL Synth Tone (SN-S) – LFO tab
36
Parameter Value Explanation
AMP Level Keyfollow
-100, -90, -80, -70, -60, -50, -40, -30,
-20, -10, 0, +10, +20, +30, +40, +50,
+60, +70, +80, +90, +100
Specify this if you want to vary the volume according to the position of the key that you play.
With the C4 key (middle C) as the base volume, “+” values will make the volume increase as you
play above C4; “-” values will make the volume decrease. Higher values will produce greater
change.
AMP Env Attack 0–127
Species the attack time of the
amp envelope.
This species the time from the
moment you press the key until
the maximum volume is reached.
Cuto
frequency
Time
Key-o
Key-on
AMP Env Decay 0–127
Species the decay time of the
amp envelope.
This species the time from when
the maximum volume is reached,
until it decays to the sustain level.
AMP Env Sustain 0–127
Species the sustain level of the
amp envelope.
This species the volume level
that will be maintained from
when the attack and decay times
have elapsed until you release
the key.
AMP Env Release 0–127
Species the release time of the
amp envelope.
This species the time from
when you release the key until
the volume reaches its minimum
value.
LFO tab
LFO Shape
Selects the LFO waveform.
TRI
Triangle wave
SIN
Sine wave
SAW
Sawtooth wave
SQR
Square wave
S&H Sample and Hold (The LFO value will change once each cycle.)
RND Random wave
LFO Rate 0–127 Species the LFO rate when Modulation LFO Tempo Sync Switch is OFF.
LFO Tempo Sync Sw OFF, ON If this is ON, the LFO rate can be specied as a note value relative to the tempo.
LFO Tempo Sync Note
16, 12, 8, 4, 2, 1, 3/4, 2/3, 1/2, 3/8, 1/3,
1/4, 3/16, 1/6, 1/8, 3/32, 1/12, 1/16,
1/24, 1/32
Species the LFO rate when Modulation LFO Tempo Sync Switch is ON.
LFO Fade Time 0–127
This species the time from when the partial sounds until the LFO reaches its maximum amplitude.
Fade Time
LFO Key Trigger OFF, ON If this is on, the LFO cycle will be restarted when you press a key.
LFO Pitch Depth -63–+63 This allows the LFO to modulate the pitch, producing a vibrato eect.
LFO FILTER Depth -63–+63 This allows the LFO to modulate the FILTER CUTOFF (cuto frequency), producing a wah eect.
LFO AMP Depth -63–+63 This allows the LFO to modulate the AMP LEVEL (volume), producing a tremolo eect.
LFO Pan Depth -63–+63 Here’s how to make the PAN (stereo position) vary (Auto Panning).