Roland INTEGRA-7

Studio Set – EQ tab
7
Parameter Value Explanation
Legato Switch OFF, ON, TONE
You can add legato when performing monophonically. The term “legato” refers to a playing style
in which notes are smoothly connected to create a owing feel. This creates a smooth transition
between notes, which is eective when you wish to simulate the hammering-on and pulling-o
techniques used by a guitarist.
Turn this parameter “ON” when you want to use the Legato feature and “OFF” when you don’t. If
you want to use the Legato Switch setting of the tone assigned to the part, set this to “TONE.”
* This is not shown in PART VIEW -ALL-.
SN-A
(Ac.Piano)
SN-A
(Organ)
SN-A
(Other)
SN-S SN-D PCMS PCMD
ü
– –
ü
–
ü
–
Voice Reserve 0–63, FULL
This setting species the number of voices that will be reserved for each part when more than 128
voices are played simultaneously.
It is not possible for the settings of all parts to total an amount greater than 64.
* This is not shown in PART VIEW -ALL-.
EQ tab
EQ Switch OFF, ON EQ for each part on/o setting
EQ Low Freq 200, 400 [Hz]
Frequency of the low range
* This is not shown in PART VIEW -ALL-.
EQ Low Gain -15–+15 [dB] Gain of the low frequency range
EQ Mid Freq
200, 250, 315, 400, 500, 630, 800,
1000, 1250, 1600, 2000, 2500, 3150,
4000, 5000, 6300,8000 [Hz]
Frequency of the middle range
* This is not shown in PART VIEW -ALL-.
EQ Mid Gain -15–+15 [dB] Gain of the middle frequency range
EQ Mid Q 0.5, 1.0, 2.0, 4.0, 8.0
Width of the middle frequency range
Set a higher value for Q to narrow the range to be aected.
* This is not shown in PART VIEW -ALL-.
EQ High Freq 2000, 4000, 8000 [Hz]
Frequency of the high range
* This is not shown in PART VIEW -ALL-.
EQ High Gain -15–+15 [dB] Gain of the high frequency range
KBD tab
Range Lower
Range Upper
Fade Lower
Fade Upper
Level
Pitch
Key Fade Upper 0–127
Determines what will happen to the Part’s level when a note that’s higher than its specied
keyboard range is played. Higher settings produce a more gradual change in volume.
If you don’t want the Tone to sound at all when a note above the keyboard range is played, set this
parameter to 0.
Key Range Upper LOWER–G9
Species the highest note that the tone will sound for each part.
* It is not possible to set Lower to a value greater than the Upper value, or Upper to a value less
than the Lower value.
Key Range Lower C-1–UPPER Species the lowest note that the tone will sound for each part.
Key Fade Lower 0–127
Determines what will happen to the Part’s level when a note that’s lower than its specied
keyboard range is played. Higher settings produce a more gradual change in volume.
If you don’t want the Tone to sound at all when a note below the keyboard range is played, set this
parameter to 0.