Roland INTEGRA-7 - IMPORTANT NOTES; Power, Placement, and Maintenance

Studio Set – GENERAL tab
5
STUDIO SET COMMON
1. In the top screen, press the [MENU] button.
2. Choose “STUDIO SET COMMON,” and press the [ENTER] button.
Parameter Value Explanation
GENERAL tab
Studio Set Tempo 20–250
Tempo for the studio set
MEMO
If the system setting “Tempo Assign Source” is set to STUDIO SET, the tempo setting of the
studio set will be used as the tempo.
If “Tempo Assign Source” is set to SYSTEM, the system’s tempo setting will be used as the
tempo.
Drum Comp+EQ Assign Part1–Part16
Species the part that will use the six sets of compressor + equalizer that are provided for use with
a drum kit.
* If a tone (not a drum kit) is assigned to the part specied by Drum Comp+EQ Assign, the
Comp+EQ will not be available.
CONTROL tab
Tone Control 1 Src
OFF, CC01–CC31, CC33–CC95, BEND,
AFT
Specify the MIDI messages that will be used for Tone Control of the studio set.
MEMO
If you want to use the Tone Control 1–4 Src settings of each studio set to control the tone,
set the system setting “Control Source Select” to STUDIO SET. If you want to use the system
settings System Control 1–4 Src to control the tone, set the system setting “Control Source
Select” to “SYSTEM.”
Tone Control 2 Src
OFF, CC01–CC31, CC33–CC95, BEND,
AFT
Tone Control 3 Src
OFF, CC01–CC31, CC33–CC95, BEND,
AFT
Tone Control 4 Src
OFF, CC01–CC31, CC33–CC95, BEND,
AFT
PHASE LOCK tab
CH 1–CH 16 OFF, ON
Set Phase Lock to “ON” when you want to suppress discrepancies in timing of parts played on the
same MIDI channel.
When the Phase Lock parameter is set to “ON,” parts on the same MIDI channel are put in
a condition in which their timing is matched, enabling them to be played at the same time.
Accordingly, a certain amount of time may elapse between reception of the Note messages and
playing of the sounds. Turn this setting to “ON” only as needed.
* Phase Lock is not available for SuperNATURAL acoustic organ-type instruments.