Roland INTEGRA-7

SuperNATURAL Synth Tone (SN-S) – MFX tab
38
Parameter Value Explanation
MFX tab
MFX Switch OFF, ON Species whether MFX will be used (ON) or not used (OFF).
MFX Type 0–67
Use this parameter to select from among the 67 available multi-eects.
For details on multi-eects parameters, refer to “MFX Parameters” (p. 73).
Parameters for each MFX type Edit the parameters for the selected MFX type.
MFX Chorus Send Level 0–127
Adjusts the amount of chorus for the sound that passes through multi-eects. If you don’t want to
add the Chorus eect, set it to “0.”
* This has no eect if motional surround is on.
MFX Reverb Send Level 0–127
Adjusts the amount of reverb for the sound that passes through multi-eects. If you don’t want to
add the Reverb eect, set it to “0.”
* This has no eect if motional surround is on.
MFX CTRL tab
Source (1–4)
OFF, CC01–31, 33–95, PITCH BEND,
AFTERTOUCH, SYS CTRL1–SYS CTRL4
Sets the MIDI message used to change the multi-eects parameter with the multi-eects control.
OFF: Multi-eects control will not be used.
CC01–31, 33–95: Control Change
PITCH BEND: Pitch Bend
AFTERTOUCH: Aftertouch
SYS CTRL1–SYS CTRL4: MIDI messages used as common multi-eects controls.
Destination (1–4)
Sets the multi-eects parameters to be controlled with the multi-eects control. The multi-eects parameters available for control will
depend on the multi-eects type. For details, refer to “MFX Parameters” (p. 97).
Sens (1–4) -63–+63
Sets the amount of the multi-eects control’s eect that is applied. To make an increase in the
currently selected value (to get higher values, move to the right, increase rates, and so on), select
a positive value; to make a decrease in the currently selected value (to get lower values, move to
the left, decrease rates, and so on), select a negative value. For either positive or negative settings,
greater absolute values will allow greater amounts of change. Set this to “0” if you don’t want to
apply the eect.