Roland INTEGRA-7

Studio Set – TONE tab
6
PART VIEW
1. In the top screen, press the [PART VIEW] button.
The PART VIEW -ALL- screen appears.
* Some of the part parameters are not shown in the
PART VIEW -ALL- screen.
2. Press the [PART VIEW] button again.
The PART VIEW screen appears.
Parameter Value Explanation
TONE tab
Tone Type
SN-A, SN-S, SN-D
PCMS, PCMD
SN-A : SuperNATURAL Acoustic Tones
SN-S : SuperNATURAL Synth Tones
SN-D : SuperNATURAL Drum Kits
PCMS : PCM Synth Tones
PCMD : PCM Drum Kits
Species the type of tone/drum kit assigned to each part.
Tone Bank
PRST, USER,
GM2 (GM2#),
ExSN1–ExSN6,
SRX01–SRX12,
ExPCM
Selects the group of the tone/drum kit assigned to each part.
• ExSN1–5 can be selected as SN-A if that expansion is loaded
• ExSN6 can be selected as SN-D if that expansion is loaded
• SRX01–12 and ExPCM can be selected as PCMS and PCMD if that expansion is loaded
Tone Number 001– Selects the number of the tone/drum kit assigned to each part.
LEVEL/CH tab
Level
(Also valid for the Ext part)
0–127
Adjust the volume of each part.
This setting’s main purpose is to adjust the volume balance between parts.
Pan L64–63R
Adjust the pan of each part.
“L64” is far left, “0” is center, and “63R” is far right.
* If motional surround is on, surround output will be enabled and this setting will be ignored.
Cho Send Level
(Also valid for the Ext part)
0–127
Adjusts the amount of Chorus for each Part.
If you don’t want to add the Chorus eect, set it to 0.
* This has no eect if motional surround is on.
Rev Send Level
(Also valid for the Ext part)
0–127
Adjusts the amount of Reverb for each Part.
If you don’t want to add the Reverb eect, set it to 0.
* This has no eect if motional surround is on.
Output Assign A, B, C, D, 1–8
Species for each part how the sound will be output.
A, B, C, D: The sound will be output in stereo to the OUTPUT A (MIX) jacks or from the OUTPUT B,
C, D jacks.
1–8: The sound will be output in monaural to the INDIVIDUAL 1–8 jacks.
Rx Switch OFF, ON
For each part, specify whether MIDI messages will be received (ON), or not (OFF).
If this is “OFF,” the part will not respond. Normally, you should leave this “ON,” but you can turn it
“OFF” when you do not want a specic part to be playing during song playback.
Rx Channel 1–16 Species the MIDI receive channel for each part.
Mono/Poly MONO, POLY, TONE
Set this parameter to “MONO” when the tone assigned to the part is to be played monophonically,
or to “POLY” when the tone is to be played polyphonically. If you want to use the Mono/Poly
setting of the tone assigned to the part (p. **), set this to “TONE.”
* This is not shown in PART VIEW -ALL-.
SN-A
(Ac.Piano)
SN-A
(Organ)
SN-A
(Other)
SN-S SN-D PCMS PCMD
ü
–
ü ü
–
ü
–