Roland INTEGRA-7

88
MFX Parameters
44: 2Voice Pitch Shifter
Shifts the pitch of the original sound. This 2-voice pitch shifter has
two pitch shifters, and can add two pitch shifted sounds to the
original sound.
L in
R in
L out
R out
Level 1
Balance W
Balance D
Balance W
Balance D
Level 2
Pan 2 R
Pan 1 L
Pan 1 R
Pan 2 L
2Voice
Pitch Shifter
2-Band
EQ
2-Band
EQ
Parameter Value Explanation
Pitch1 Coarse #1 -24–+12 semi
Adjusts the pitch of Pitch Shift 1 in
semitone steps.
Pitch1 Fine #1 -100–+100 cent
Adjusts the pitch of Pitch Shift Pitch
1 in 2-cent steps.
Pitch1 Delay 0–1300 ms, note
Adjusts the delay time from the
direct sound until the Pitch Shift 1
sound is heard.
Pitch1 Feedback
#
-98–+98 %
Adjusts the proportion of the pitch
shifted sound that is fed back into
the eect. Negative “-” settings will
invert the phase.
Pitch1 Pan # L64–63R
Stereo location of the Pitch Shift 1
sound
Pitch1 Level 0–127 Volume of the Pitch Shift 1 sound
Pitch2 Coarse #2 -24–+12 semi
Settings of the Pitch Shift 2 sound.
The parameters are the same as for
the Pitch Shift 1 sound.
Pitch2 Fine #2 -100–+100 cent
Pitch2 Delay 0–1300 ms, note
Pitch2 Feedback
#
-98–+98 %
Pitch2 Pan # L64–63R
Pitch2 Level 0–127
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Balance #
D100:0W
–D0:100W
Volume balance between the direct
sound (D) and the pitch shifted
sound (W)
Level 0–127 Output Level
45: Overdrive -> Chorus
L in
R in
Chorus
Overdrive
L out
R out
Balance W
Balance W
Balance D
Balance D
Parameter Value Explanation
Overdrive
Drive #
0–127
Degree of distortion
Also changes the volume.
Overdrive Pan # L64–63R
Stereo location of the overdrive
sound
Chorus Pre Delay 0.0–100.0 ms
Adjusts the delay time from the
direct sound until the chorus sound
is heard.
Chorus Rate #
0.05–10.00 Hz,
note
Frequency of modulation
Chorus Depth 0–127 Depth of modulation
Chorus Balance #
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the chorus (W) and the
sound that is not sent through the
chorus (D).
Level 0–127 Output Level
46: Overdrive -> Flanger
L in
R in
Flanger
Overdrive
L out
R out
Balance W
Balance W
Balance D
Balance D
Feedback
Parameter Value Explanation
Overdrive
Drive #
0–127
Degree of distortion
Also changes the volume.
Overdrive Pan # L64–63R
Stereo location of the overdrive
sound
Flanger Pre
Delay
0.0–100.0 ms
Adjusts the delay time from when
the direct sound begins until the
anger sound is heard.
Flanger Rate #
0.05–10.00 Hz,
note
Frequency of modulation
Flanger Depth 0–127 Depth of modulation
Flanger
Feedback #
-98–+98 %
Adjusts the proportion of the
anger sound that is fed back into
the eect. Negative “-” settings will
invert the phase.
Flanger Balance
#
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the anger (W) and the
sound that is not sent through the
anger (D).
Level 0–127 Output Level