91
MFX Parameters
54: GuitarAmpSim -> Flanger
L in
R in
Flanger
Pre Amp
L out
R out
Balance W
Balance W
Balance D
Feedback
Speaker
Parameter Value Explanation
Amp Sw OFF, ON Turns the amp switch on/o.
Amp Type
Type of guitar
amp
JC-120, CLEAN TWIN, MATCH DRIVE,
BG LEAD, MS1959I, MS1959II,
MS1959I+II, SLDN LEAD, METAL5150,
METAL LEAD, OD-1, OD-2, TURBO,
DISTORTION, FUZZ
Amp Volume # 0–127
Volume and amount of distortion
of the amp
Amp Master # 0–127 Volume of the entire pre-amp
Amp Gain
LOW, MIDDLE,
HIGH
Amount of pre-amp distortion
Amp Bass
0–127
Tone of the bass/mid/treble
frequency range
* Middle cannot be set if “Match
Drive” is selected as the Pre Amp
Type.
Amp Middle
Amp Treble
Flanger Switch # OFF, ON Flanger on/o
Flanger Pre
Delay
0.0–100.0 ms
Adjusts the delay time from when
the direct sound begins until the
anger sound is heard.
Flanger Rate
(Hz) #
0.05–10.00 Hz Frequency of modulation
Flanger Depth # 0–127 Depth of modulation
Flanger
Feedback #
-98–+98 %
Adjusts the proportion of the
anger sound that is fed back into
the eect. Negative “-” settings will
invert the phase.
Flanger Balance
#
D100:0W–
D0:100W
Adjusts the volume balance
between the sound that is sent
through the anger (W) and the
sound that is not sent through the
anger (D).
Speaker Sw OFF, ON
Selects whether the sound will be
sent through the speaker simulation
(ON) or not (OFF)
Speaker Type
(See the table
below.)
Type of speaker
Level 0–127 Output Level
Specications of each Speaker Type
The speaker column indicates the diameter of each speaker unit (in
inches) and the number of units.
Type Cabinet Speaker Microphone
SMALL 1 small open-back enclosure 10 dynamic
SMALL 2 small open-back enclosure 10 dynamic
MIDDLE open back enclosure 12 x 1 dynamic
JC-120 open back enclosure 12 x 2 dynamic
BUILT-IN 1 open back enclosure 12 x 2 dynamic
BUILT-IN 2 open back enclosure 12 x 2 condenser
BUILT-IN 3 open back enclosure 12 x 2 condenser
BUILT-IN 4 open back enclosure 12 x 2 condenser
BUILT-IN 5 open back enclosure 12 x 2 condenser
BG STACK 1 sealed enclosure 12 x 2 condenser
BG STACK 2 large sealed enclosure 12 x 2 condenser
Type Cabinet Speaker Microphone
MS STACK 1 large sealed enclosure 12 x 4 condenser
MS STACK 2 large sealed enclosure 12 x 4 condenser
METAL STACK large double stack 12 x 4 condenser
2-STACK large double stack 12 x 4 condenser
3-STACK large triple stack 12 x 4 condenser
55: GuitarAmpSim -> Phaser
Pre
Amp
Speaker
Phaser
Mix
Parameter Value Explanation
Amp Sw OFF, ON Turns the amp switch on/o.
Amp Type
Type of guitar
amp
JC-120, CLEAN TWIN, MATCH DRIVE,
BG LEAD, MS1959I, MS1959II,
MS1959I+II, SLDN LEAD, METAL5150,
METAL LEAD, OD-1, OD-2, TURBO,
DISTORTION, FUZZ
Amp Volume # 0–127
Volume and amount of distortion
of the amp
Amp Master # 0–127 Volume of the entire pre-amp
Amp Gain
LOW, MIDDLE,
HIGH
Amount of pre-amp distortion
Amp Bass
0–127
Tone of the bass/mid/treble
frequency range
* Middle cannot be set if “Match
Drive” is selected as the Pre Amp
Type.
Amp Middle
Amp Treble
Phaser Switch # OFF, ON Phaser on/o
Phaser Manual # 0–127
Center frequency at which the
sound is modulated
Phaser
Resonance #
0–127 Amount of feedback
Phaser Mix # 0–127 Volume of phase-shifted sound
Phaser Rate
(Hz) #
0.05–10.00 Hz Modulation rate
Phaser Depth # 0–127 Modulation depth
Speaker Sw OFF, ON
Selects whether the sound will be
sent through the speaker simulation
(ON) or not (OFF)
Speaker Type
(See the table
below.)
Type of speaker
Level 0–127 Output Level
To Next Page
Loading...
