Roland INTEGRA-7

81
MFX Parameters
23: Flanger
This is a stereo anger. (The LFO has the same phase for left and
right.) It produces a metallic resonance that rises and falls like a jet
airplane taking o or landing. A lter is provided so that you can
adjust the timbre of the anged sound.
R in
R out
L in
L out
Flanger
Feedback
Feedback
Flanger
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Parameter Value Explanation
Filter Type OFF, LPF, HPF
Type of lter
OFF: no lter is used
LPF: cuts the frequency range above
the Cuto Freq
HPF: cuts the frequency range
below the Cuto Freq
Cuto Freq 200–8000 Hz Basic frequency of the lter
Pre Delay 0.0–100.0 ms
Adjusts the delay time from when
the direct sound begins until the
anger sound is heard.
Rate #
0.05–10.00 Hz,
note
Frequency of modulation
Depth 0 –127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback # -98–+98 %
Adjusts the proportion of the
anger sound that is fed back into
the eect. Negative “-” settings will
invert the phase.
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Balance #
D100:0W
–D0:100W
Volume balance between the direct
sound (D) and the anger sound (W)
Level 0 –127 Output Level
24: Step Flanger
This is a anger in which the anger pitch changes in steps. The
speed at which the pitch changes can also be specied in terms of a
note-value of a specied tempo.
R in
R out
L in
L out
Feedback
Feedback
Balance W
Balance D
Balance W
Balance D
2-Band
EQ
2-Band
EQ
Step Flanger
Step Flanger
Parameter Value Explanation
Filter Type OFF, LPF, HPF
Type of lter
OFF: no lter is used
LPF: cuts the frequency range above
the Cuto Freq
HPF: cuts the frequency range
below the Cuto Freq
Cuto Freq 200–8000 Hz Basic frequency of the lter
Pre Delay 0.0–100.0 ms
Adjusts the delay time from when
the direct sound begins until the
anger sound is heard.
Rate #
0.05–10.00 Hz,
note
Frequency of modulation
Depth 0–127 Depth of modulation
Phase 0–180 deg Spatial spread of the sound
Feedback # -98–+98 %
Adjusts the proportion of the
anger sound that is fed back into
the eect. Negative “-” settings will
invert the phase.
Step Rate #
0.10–20.00 Hz,
note
Rate (period) of pitch change
Low Gain -15–+15 dB Gain of the low range
High Gain -15–+15 dB Gain of the high range
Balance #
D100:0W
–D0:100W
Volume balance between the direct
sound (D) and the anger sound (W)
Level 0–127 Output Level