Roland INTEGRA-7

Studio Set – PITCH tab
8
Parameter Value Explanation
Range Lower
Range Upper
Fade Lower
Fade Upper
Level
Velocity
Velo Fade Upper 0–127
Determines what will happen to the tone’s level when the tone is played at a velocity greater than
Velo Range Upper. If you don’t want the tone to sound at all, set this parameter to “0.”
* This is not shown in PART VIEW -ALL-.
SN-A
(Ac.Piano)
SN-A
(Organ)
SN-A
(Other)
SN-S SN-D PCMS PCMD
ü
–
ü ü ü ü ü
Velo Range Upper LOWER–127
Species the highest velocity at which the part will sound.
* This is not shown in PART VIEW -ALL-.
Velo Range Lower 1–UPPER
Species the lowest velocity at which the part will sound.
* This is not shown in PART VIEW -ALL-.
Velo Fade Lower 0–127
Determines what will happen to the tone’s level when the tone is played at a velocity lower than
Velo Range Lower. If you don’t want the tone to sound at all, set this parameter to “0.”
* This is not shown in PART VIEW -ALL-.
SN-A
(Ac.Piano)
SN-A
(Organ)
SN-A
(Other)
SN-S SN-D PCMS PCMD
ü
–
ü ü ü ü ü
Velo Sens Oset -63–+63
Adjusts the velocity sensitivity. The higher the value, the greater the sensitivity.
* This is not shown in PART VIEW -ALL-.
SN-A
(Ac.Piano)
SN-A
(Organ)
SN-A
(Other)
SN-S SN-D PCMS PCMD
ü
– –
ü ü ü ü
PITCH tab
Octave Shift -3–+3
Adjusts the pitch of the part’s sound up or down in units of an octave (+/-3 octaves).
SN-A
(Ac.Piano)
SN-A
(Organ)
SN-A
(Other)
SN-S SN-D PCMS PCMD
ü ü ü ü
–
ü
–
Coarse Tune -48–+48 Adjusts the pitch of the part’s sound up or down in semitone steps (+/-4 octaves).
Fine Tune -50–+50
Adjusts the pitch of the part’s sound up or down in 1-cent steps (+/- 50 cents).
MEMO
One cent is 1/100th of a semitone.
Bend Range 0–24, TONE
Species the amount of pitch change in semitones (2 octaves) that will occur when the Pitch Bend
Lever is moved. The amount of change when the lever is tilted is set to the same value for both left
and right sides. If you want to use the Pitch Bend Range setting of the tone assigned to the part,
set this to “TONE.”
SN-A
(Ac.Piano)
SN-A
(Organ)
SN-A
(Other)
SN-S SN-D PCMS PCMD
ü ü ü ü
–
ü ü
Porta Switch OFF, ON, TONE
Specify whether portamento will be applied. Turn this parameter “ON” when you want to apply
Portamento and “OFF” when you don’t. If you want to use the Portamento Switch setting of the
tone assigned to the part, set this to “TONE.”
* This is not shown in PART VIEW -ALL-.
SN-A
(Ac.Piano)
SN-A
(Organ)
SN-A
(Other)
SN-S SN-D PCMS PCMD
ü
–
ü ü
–
ü
–