Roland INTEGRA-7 - MIDI Implementation Chart; MIDI Message Details

PCM Synth Tone (PCMS) – TVA ENV tab
59
Parameter Value Explanation
Partial Pan
L64–63R
Sets the pan of the partial. “L64” is far left, “0” is center, and “63R” is far right.
* You can control this parameter using the Matrix Control.
Pan Keyfollow -100–+100
Use this parameter if you want key position to aect panning. Positive “+” settings will cause notes
higher than C4 key (center C) to be panned increasingly further toward the right, and negative
“-” settings will cause notes higher than C4 key (center C) to be panned toward the left. Larger
settings will produce greater change.
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
o
L
R
Pan
Key
Random Pan Depth 0–63
Use this parameter when you want the stereo location to change randomly each time you press a
key. Higher settings will produce a greater amount of change.
Alternate Pan Depth L63–63R
This setting causes panning to be alternated between left and right each time a key is pressed.
Higher settings will produce a greater amount of change. “L” or “R” settings will reverse the order
in which the pan will alternate between left and right. For example if two tones are set to “L” and
“R” respectively, the panning of the two tones will alternate each time they are played.
NOTE
In the Pan Key Follow, Random Pan Depth, Alternate Pan Depth parameter settings, if the
Structure Type set in the range of “2”–”10,” the output of partial 1 and 2 will be combined into
partial 2, and the output of partial 3 and 4 will be combined into partial 4.
For this reason, partial 1 will follow the settings of partial 2, and partial 3 will follow the settings
of partial 4 (p. 52).
TVA ENV tab
TVA Env T1 V-Sens -63–+63
This allows keyboard dynamics to aect the Time 1 of the TVA envelope. If you want Time 1 to be
speeded up for strongly played notes, set this parameter to a positive “+” value. If you want it to be
slowed down, set this to a negative “-” value.
TVA Env T4 V-Sens -63–+63
The parameter to use when you want key release speed to control the Time 4 value of the TVA
envelope. If you want Time 4 to be speeded up for quickly released notes, set this parameter to a
positive “+” value. If you want it to be slowed down, set this to a negative “-” value.
TVA Env Time KF -100–+100
Use this setting if you want the TVA envelope times (Time 2–Time 4) to be aected by the keyboard
location. Based on the TVA envelope times for the C4 key (center C), positive “+” settings will cause
notes higher than C4 to have increasingly shorter times, and negative “-” settings will cause them
to have increasingly longer times. Larger settings will produce greater change.
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
Key
Time
TVA Env Time 1–4
0–127
Specify the TVA envelope times (Time 1– Time 4). Higher settings will lengthen the time until the
next volume level is reached. (For example, Time 2 is the time over which Level 1 will change to
Level 2.)
* You can control this parameter using the Matrix Control.