16
04 Registrations are Convenient for Live Performance
Selecting a Sound for the Percussion/Lower Part
1.
In the Top screen (p. 35), press the [LOWER TONE] button so it’s lit.
The Percussion/Lower Part will turn on.
The cursor will move to the sound number for the Percussion/Lower Part.
2. Press the [ENTER] button.
A sound list will appear.
3. Press the [F1] (SN.AC) or [F2] (SN.SYN) button, to SuperNATURAL Acoustic or Synth.
4. Use the [ ] [ ] (cursor) buttons to select a category, and use the [ ] [ ] (cursor) buttons to select a tone.
5. Press the [ENTER] button.
The tone for the Percussion/Lower Part will be selected.
Selecting a Sound for the Solo Part
1.
In the Top screen (p. 35), press the SOLO button.
The tone for the Solo Part will be selected.
If the Solo Part was o when you selected a tone, the Solo Part will automatically be switched on.
2. Press the same solo button once again.
The solo tone list will appear.
3. Turn the value dial to select a tone, and press the [ENTER] button.
This allows you to select other sounds of the selected category.
Saving a Registration
1.
In the Top screen (p. 35) or the REGISTRATION screen (p. 36), press the [WRITE] button.
Registration number
2. Move the cursor to the position shown in the illustration to select the save destination, and press the [F6] (WRITE) button.
3. Press the [F5] (OK) button.
The screen will indicate “Completed!”
The Registration has been saved.
If the Live Set has also been edited, it can
be saved at the same time (p. 55).
To Next Page
Loading...
