104
Effects and GEQ
Effects and GEQ
About the GEQ
fig.GEQDia.eps
The M-480 provides twelve GEQ processors, GEQ 1–12, that can be used as 31-band GEQ or 8-band parametric EQ. You can insert a GEQ
processor into the AUX 1–16, MTX 1–8, or MAIN L/R/C.
The GEQ1–6 tab or GEQ 7–12 tab of the EFFECTS screen is used to perform effect operations.
INPUT OUTPUT
31-BAND GEQ
or
8-BAND PEQ
GEQ 1
OUTPUT
SELECT
INPUT
SELECT
Same as the above
GEQ 2
Same as the above
GEQ 12
AUX 1–16 INSERT OUT
MTX 1–8 INSERT OUT
MAIN L, R, C INSERT OUT
To AUX 1–16 INSERT IN
To MTX 1–8 INSERT IN
To MAIN L, R, C INSERT IN
1.
Access the EFFECTS screen.
2.
Press [F2 (GEQ 1–6)] (or [F3 (GEQ 7–12)]) to display the
GEQ 1–6 (or GEQ 7–12) tab.
fig.ScrGEQRack_Guide.eps
GEQ 1–6 (GEQ 7–12)
fig.ScrGEQRack_Guide2.eps
This shows GEQ 1–6 (GEQ 7–12). This area is organized as
follows:
GEQ number indication
This indicates the GEQ number.
GEQ INSERT SELECT popup button
This selects the channel into which the GEQ will be inserted.
The selected channel is shown on the button. When you
move the cursor to the button and press [ENTER], the GEQ
INSERT SELECT popup will appear.
EDIT button
This accesses the corresponding GEQ EDIT popup.
IN meters
These indicate the input level to the GEQ.
GEQ state indication
This indicates the state of the GEQ.
OUT meters
These indicate the output level from the GEQ.
BYPASS buttons
This turns the bypass on/off. When this is on, the input signal
will be “thru-ed” to the output.
You can also make the setting for switching bypass on or off
from a USER button (p. 140).
LINK button
This links adjacent odd-numbered and even-numbered GEQ
processors. If they are linked, the GEQ settings will be
identical.
When you activate LINK, the odd-numbered processor’s settings
will be applied to the even-numbered processor.
Accessing the GEQ 1–6 (GEQ 7–12) tab
1
1
2
3
4
5
6 7 81
1
2
3
4
5
6
7
8
M-480_e.book 104 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
