Roland M-480 - Linking Scene Memories to M-48 Memories

126
Scene memory
Scene memory
The parameter recall scope buttons correspond to the
following parameters:
• For CH1–48 and RTN 1–6
*: CH 1–48 only.
• For AUX/MTX/MAIN
Channel recall scope buttons
These buttons specify the channels that will be included in
the recall scope.
De-select the channels that you don’t want to be recalled.
OTHER parameter recall scope buttons
Use these to specify other parameters that will be included
in the scope of recall.
De-select the parameters that you don’t want to be recalled.
The function buttons have the following operations:
1.
Access the SCENE screen.
2.
Press [F6 (GLOBAL SCOPE)] to access the GLOBAL SCOPE
popup.
3.
Use the channel recall scope buttons of [F1 (CH 1–48)]
and [F2 (RTN 1–6)] to specify the channel recall scope.
4.
Specify the scope of parameters that will be recalled for
CH 1–48 and RTN 1–6.
5.
Use the channel recall scope buttons of [F3 (AUX/MTX/
MAIN)] to specify the channel recall scope.
6.
Specify the scope of parameters that will be recalled for
AUX, MTX and MAIN.
7. Use the OTHER parameter recall scope buttons of [F4
(OTHER)] to specify the other parameters that will be
recalled.
8.
Press [F8 (CLOSE)] to close the popup.
Item
Explanation
Preamp
Preamp gain, pad, and +48V phantom power
Phase Phase
ATT Attenuator
HPF* High-pass filter
Gate* Gate/Expander
Comp* Compressor
Delay Delay
EQ* 4-band EQ
Fader Faders
Pan Pan
LCR LCR button, CENTER
Send AUX/MTX sends
Direct Direct out point
Mute Mute
To MAIN MAIN send
Item
Setting
ATT Attenuator
EQ 4-band EQ
Fader Faders
Balance Balance
LCR LCR button, CENTER
Phase
Phase
Limiter Limiter
Delay Delay
MTX Send MTX sends
Mute Mute
To MAIN MAIN send
2
[F1 (CH 1–48)]
Displays CH1–48 as the channel recall scope
buttons.
[F2 (RTN 1–6)] Displays RTN 1–6 as the channel recall scope
buttons.
[F3 (AUX/MTX/MAIN)] Displays AUX1–16, MTX1–8, and MAIN L/R/C as
the channel recall scope buttons.
[F4 (OTHER)] Displays the OTHER parameter recall scope
buttons.
[F8 (CLOSE)] Closes the popup.
Using the Global Scope function
3
Linking scene memories to M-48 memories
If desired, M-48 memories can be stored simultaneously when a
scene memory is stored on the M-480.
The current memory of each M-48 unit will be stored to the
specified memory number (except for M-48 units whose
MEMORY SAFE function (p. 175) is on).
Scenes stored by this operation are set so that when they are
recalled, the memories of the M-48 units will also be recalled.
1. Access the SCENE screen.
2.
Select the scene number to use as the destination for the
store operation, and press [F2 (STORE)].
fig.ScrSceneStore2.eps
The SCENE STORE popup will appear.
3.
Verify the scene name shown in the name edit field, and
edit it if desired.
The M-48 memory will be stored with the same name.
Linking M-48 store operations
M-480_e.book 126 ページ ２０１１年３月２日 水曜日 午前９時２０分