110
Inserting an external effects device
Inserting an external effects device
fig.ExtInsDia.eps
You can use the CONSOLE IN 1–8 and CONSOLE OUT 1–8 jacks located on the M-480’s rear panel to insert up to eight external effects
devices into channels. The eight external effects devices are shown virtually as an EXT FX1–8 rack, allowing you to adjust the input levels
and insert them into channels.
EXT FX1–8 use the following input/output jacks:
To insert external effects devices into channels, you’ll use the EXT FX 1–6 tab and EXT FX 7–8 tab of the EFFECTS screen.
About inserting an external effects device
External effect
Output jack Input jack
EXT FX1
CONSOLE OUT 1 CONSOLE IN 1
EXT FX2 CONSOLE OUT 2 CONSOLE IN 2
EXT FX3 CONSOLE OUT 3 CONSOLE IN 3
EXT FX4 CONSOLE OUT 4 CONSOLE IN 4
EXT FX5 CONSOLE OUT 5 CONSOLE IN 5
EXT FX6 CONSOLE OUT 6 CONSOLE IN 6
EXT FX7 CONSOLE OUT 7 CONSOLE IN 7
EXT FX8 CONSOLE OUT 8 CONSOLE IN 8
SEND RETURN
EXT FX 1–8
OUTPUT
SELECT
INPUT
SELECT
CONSOLE INPUT 1–8
TO CONSOLE OUTPUT 1–8
SEND
LEVEL
RETURN
LEVEL
CH 1–48 INSERT OUT
AUX 1–16 INSERT OUT
MTX 1–8 INSERT OUT
MAIN L, R, C INSERT OUT
To CH 1–48 INSERT IN
To AUX 1–16 INSERT IN
To MTX 1–8 INSERT IN
To MAIN L, R, C INSERT IN
fig.ScrExtRackGuide.eps
EXT FX 1–6 (EXT FX 7–8)
fig.ScrExtRackGuide2.eps
This area indicates the status of EXT FX. It is organized as follows:
External effect number
This indicates the number of the external effect.
ENABLE button
This enables or disables the EXT FX.
If you turn the ENABLE button on, you’ll be able to use the
corresponding CONSOLE IN jack and CONSOLE OUT jack to
insert your external effects device into the assigned channel,
and the buttons, knobs, and meters – described below
will be shown.
EXT FX INSERT SELECT popup button
This selects the channel into which the external effect will be
inserted. The selected channel is shown on the button.
When you move the cursor to the button and press [ENTER],
the EXT FX INSERT SELECT popup will appear.
SEND LEVEL knob
This adjusts the output level to the external effect in a range
of -Inf dB–+6.0 dB.
The CONSOLE OUT jack is fixed at a nominal output level of +4
dBu. The SEND LEVEL knob adjusts the output level in the digital
domain.
OUT meter
This indicates the level of the signal being output to the
external effect.
RETURN LEVEL knob
This adjusts the input level from the external effect in a
range of -Inf dB–+6.0 dB.
When you’re using it for insertion of an external effects device,
the CONSOLE IN jack’s nominal input level is fixed at +4 dBu.
The RETURN LEVEL knob adjusts the input level in the digital
domain.
IN meter
This indicates the level of the signal being input from the
external effect.
EXT FX 1–6 (EXT FX 7–8) tab
1
1
2
3
4
5
6 71
1
2
3 7
3
4
5
6
7
M-480_e.book 110 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
