Roland M-480 - Inserting an External Effects Device into a Channel

111
Inserting an external effects device
Inserting an external effects device
Inserting an external effects device into a channel
To insert an external effects device into a channel, connect the
CONSOLE IN jack and CONSOLE OUT jack to your external effects
device, and insert the corresponding EXT FX into the desired
channel.
The EXT FX INSERT SELECT popup is used to insert an EXT FX into
a channel.
1.
Press the top panel [EFFECTS] button to access the
EFFECTS screen.
2.
Press [F4 (EXT FX 1–6)] (F5 (EXT FX 7–8)]) to access the
EXT FX 1–6 (EXT FX 7–8) tab.
fig.ScrEXT.eps
3.
Move the cursor to the EXT FX INSERT SELECT popup
button for the desired EXT FX, and press [ENTER].
fig.ScrEXTInsSelGuide.eps
The EXT FX INSERT SELECT popup will appear.
Current insert-destination indication
This indicates the current insert-destination.
Applicable EXT FX indication
This indicates the EXT FX to which the EXT FX INSERT SELECT
popup applies.
Insert-destination select buttons
These buttons select the channel into which the EXT FX will
be inserted.
The function buttons have the following operations:
Here we’ll explain how to connect your external effects device to
CONSOLE IN1 and CONSOLE OUT1, and insert it into CH1.
1.
Access the EXTERNAL INSERT screen.
2. Move the cursor to the ENABLE button for EXT FX1, and
press [ENTER] to select it.
3.
Connect your external effects device to CONSOLE IN1
and CONSOLE OUT1.
fig.ExtFxConnect.eps
If you connect your external effects device while the EXT FX
ENABLE button is off, the input and output may loop.
If the EXT FX insert-destination is already specified when you
connect your external effects device, noise may be heard in
the channel.
4. Move the cursor to the EXT FX INSERT SELECT popup
button for EXT FX1, and press [ENTER].
The EXT FX INSERT SELECT popup will appear.
5.
Move the cursor to the CH1 insert-destination channel
select button, and press [ENTER] to select it.
fig.ScrEXTInsSel.eps
6.
Press [F8 (CLOSE)] to close the popup.
Accessing the EXT FX INSERT SELECT
popup
21 3
1
2
3
[F1 (CH 1–48 INSERT)]
Displays CH1–48 as the insert-destination
channel select buttons.
[F2 (BUS INSERT)] Displays AUX1–16, MTX1–8, and MAIN L/R/C as
the insert-destination channel select buttons.
[F6 (SELECT NONE)] Clears the insert-destination selection.
[F8 (CLOSE)] Closes the popup.
Inserting an EXT FX into a channel
External Effect
Device
C
ONSOLE OUT 1
ONSOLE OUT 1
CONSOLE OUT1
INPUT OUTPUT
C
ONSOLE IN 1
ONSOLE IN 1
CONSOLE IN1
M-480_e.book 111 ページ ２０１１年３月２日 水曜日 午前９時２０分