76
Dynamics
Dynamics
Compressors are provided on CH1–
48
.
They apply a user-adjustable ratio of attenuation to input signals that exceed the threshold level.
fig.CompCurve.eps
The COMPRESSOR popup is used to perform compressor operations.
Compressor operations
INPUT LEVEL TIME
OUTPUT LEVEL
LEVEL
THRESHOLD
THRESHOLD
ATTACK
RELEASE
INPUT SIGNAL
OUTPUT SIGNAL
RATIO
(KNEE=HARD, GAIN=0.0dB, AUTO GAIN=OFF) (RATIO=INF:1)
1.
In the fader module section, press a [SEL] button to select
the desired channel.
2.
In the COMP area of the CHANNEL EDIT section, press
[DISP].
fig.PopComp.eps
The COMPRESSOR popup will appear.
fig.PopCompGuide.eps
KEY-IN meter
This indicates the level of the key-in signal. For stereo-linked
channels, two meters (L and R) are shown.
IN meter
This indicates the input level to the compressor. For stereo-
linked channels, two meters (L and R) are shown.
GR (Gain Reduction) meter
This indicates the amount of gain reduction produced by the
compressor.
Compressor graph
This indicates the approximate response of the compressor.
OUT meter
This indicates the output level of the compressor. For stereo-
linked channels, two meters (L and R) are shown.
Parameters
In this field you can edit the compressor parameters.
fig.PopCompGuide2.eps
THRESH knob
This adjusts the threshold level in a range of -40.0 dB–0.0 dB.
Accessing the COMPRESSOR popup
COMPRESSOR popup
2
1
3
4 5
8
6
7
1
2
3
4
5
6
1 2
3
4
5
6
1
M-480_e.book 76 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
Need help?
General
