97
Metering
Metering
range of 0 dB – -48 dB.
AVG (average)
Here you can select the averaging method for the analyzer:
AVG TIMES (average times)
This specifies the value (1–128) by which the analyzer’s
display will be averaged.
PEAK HOLD button
When this is on, the analyzer’s peaks will be held.
The Hold time is specified by the HOLD TIME setting of the
METER SETUP popup.
.
OFF
Averaging will not be performed.
NRM Averages evenly by the number specified in the
AVG TIMES.
EXP Recent times will be weighted more heavily in the
calculation.
4
5
6
If the M-480 and M-480RCS (software that remotely controls
the M-480 from a PC) attempt to display the analyzer
simultaneously, display on the M-480 will take priority. In this
case, the analyzer levels will not be shown in the M-480RCS
window (as shown below).
Listing the channel names and group names
fig.ScrMeterList_Guide.eps
Name list
This lists the names of each channel and group.
fig.List_Compo_Guide.eps
Name
This is the name of the channel or group. If you move the
cursor to the name of a channel, that channel will become
the selected channel.
Link indication
This indicates the link status of the channel.
To change the link status of a channel, move the cursor to the
name of the desired channel, and press [F5 (LINK)] to turn link
on/off.
The function buttons specific to the NAME LIST tab have the
following operations:
*1 This is unavailable if the cursor is at RTN1–6, MAIN L, MAIN R, DCA1–
8, or MUTE1–8.
*2 This is unavailable if the cursor is at DCA1–8 or MUTE1–8.
NAME EDIT popup (p. 52).
CHANNEL COPY popup (p. 53).
AUX/MTX/MAIN COPY popup (p. 66).
NAME LIST tab
1
1
2
1
1
2
[F5 (LINK)]
*1
Turns link on/off for the channel at the cursor
location.
[F6 (NAME EDIT)] Accesses the NAME EDIT popup, where you can
edit the name at the cursor location.
[F7 (COPY)]
*2
Accesses the COPY popup, with the channel at
the cursor location as the copy-source.
M-480_e.book 97 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
