Roland M-480 - Editing the User Fader Layers

139
User settings
User settings
Editing the user fader layers
The user fader layers are a function for assigning any channel to
the top panel fader module section (p. 21). There are three user
fader layers, and you can assign any 24 channels for each user
layer.
1.
Access the USER screen.
2. From the user list, select the desired user.
3.
Press [F6 (USER PREF)].
The USER PREFERENCE popup will appear.
4.
Press the button from [F1 (LAYER 1)] through [F3 (LAYER
3)] that matches the user fader layer whose settings you
want to make.
fig.ScrUserFaderGuide.eps
The USER FADER tab will appear.
Applicable user indication
This indicates the user settings to which the USER
PREFERENCE popup applies.
User fader assign 1–24
This area indicates the channels that are assigned to user
faders 1–24.
The function buttons have the following operations:
5.
Move the cursor to the desired user fader assignment,
and press [ENTER].
fig.ScrUserFdrAsgn.eps
The USER FADER ASSIGN popup will appear.
Current assignment
This indicates the channel that is currently assigned to the
user fader.
Applicable user fader
This indicates the user fader to which the USER FADER
ASSIGN setting applies.
Assignment channel select buttons
Here you can select the channel that will be assigned to the
user fader. The selected channel will be assigned to the user
fader.
The function buttons have the following operations:
6.
Use [F1]–[F3] to access the tab that contains the desired
channel.
7.
Move the cursor to the desired channel, and press
[ENTER] to select it.
8.
Press [F8 (CLOSE)] to finalize the changes and close the
USER FADER ASSIGN popup.
9.
Press [F8 (OK)] to finalize the changes and close the USER
PREFERENCE popup.
Pressing [F7 (CANCEL)] will cancel the operation.
As an alternative to pressing [ENTER] in step 5, you can use the
value dial or [SEL] button to edit the user fader assignment.
Editing the user fader layer assignments
[F1 (LAYER 1)]
Accesses the LAYER 1 tab.
[F2 (LAYER 2)] Accesses the LAYER 2 tab.
[F3 (LAYER 3)] Accesses the LAYER 3 tab.
[F4 (BUTTON 1–8)] Accesses the BUTTON 1–8 tab.
[F5 (BUTTON 9–16)] Accesses the BUTTON 9–16 tab.
[F6 (OTHER)] Accesses the OTHER tab.
[F7 (CANCEL)] Cancels the changes and closes the popup.
[F8 (OK)] Confirms the changes and closes the popup.
21
1
2
[F1 (CH 1–48)]
Displays CH1–48 as the assignment channel
select buttons.
[F2 (RTN 1–8
DCA)]
Displays RTN1–8 and DCA1–8 as the
assignment channel select buttons.
[F3 (AUX/MTX/MAIN)] Displays AUX1–16, MTX1–8, and MAIN L/R/C as
the assignment channel select buttons.
[F6 (PREV FADER)] Changes the target user fader.
[F7 (NEXT FADER)]
[F8 (CLOSE)] Confirms the changes and closes the popup.
2
1
3
1
2
3
M-480_e.book 139 ページ ２０１１年３月２日 水曜日 午前９時２０分