178
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
3.
Press [F7 (RESET)].
fig.ScrM48Pref_Conf.eps
A message will ask you to confirm the operation.
4.
Press [F8 (RESET)] to return the preference settings to
their default state.
The preference settings will be set to the following values:
Pressing [F7 (CANCEL)] will cancel the operation.
1.
Access the desired M-48 SETUP popup.
2.
In the GROUP MIX (VOLUME) area, move the cursor to the
desired group name and press [ENTER].
fig.ScrM48GrpName.eps
The NAME EDIT popup will appear.
3.
Use the name edit field to edit the name.
For details on name editing, refer to “Editing a name” (p. 39).
4.
Press [F8 (OK)] to finalize the edited name and close the
popup.
Pressing [F7 (CANCEL)] will cancel the operation.
Parameter
Values
SOLO
MODE ADD ON
LAYER select clears SOLO No
MEMORY Disable RECALL button No
Disable STORE button No
LINE OUT SOURCE MAIN BUS
LPF OFF
MONO OFF
Assigning group names for an M-48 unit
Source Level/Pan settings
This popup lets you set the LEVEL, PAN, and AUX switch for each
source 1–40. Two views are provided:
• SOURCE LAYOUT tab
fig.ScrM48SrcLev1.eps
This shows the sources arranged in order of their number
(the order in the M-480’s REAC B output patchbay).
• M-480 LAYOUT tab
fig.ScrM48SrcLev2.eps
This shows the sources as they are seen from the M-480’s
fader module section. This display will change according to
the M-480’s fader layer.
Nothing is shown at the position of sources that are not patched
to the REAC B output.
If the same channel is being output multiple times to REAC B,
only the lowest-numbered output will be operable.
M-48 SOURCE LEV/PAN popup
The following outputs cannot be operated in the M-480
LAYOUT tab because they do not appear in the M-480’s top
panel fader module section:
• MAIN L, MAIN R, MAIN MONO
• MONITOR L, MONITOR R
• REC L, REC R
• TALKBACK/OSC
• REAC A IN1–40, REAC B IN1–40
• CONSOLE IN1–8
• STEREO IN L, STEREO IN R
M-480_e.book 178 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
