Roland M-480 - Page 179

179
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
fig.ScrM48SrcLev_Guide.eps
Target M-48 indication
This shows the unit name of the M-48 that is the target of the
M-48 SOURCE LEV/PAN.
Source LEVEL/PAN
fig.ScrM48SrcLevEmnt_Guide.eps
Source number/name indication
In the SOURCE LAYOUT tab, this indicates the source number
and name. In the M-480 LAYOUT tab, this indicates the M-
480’s channel number and name.
The M-480’s channel name or output name is used as the source
name.
In the SOURCE LAYOUT tab, the names of sources for which
nothing is being output from the M-480’s REAC B are not shown;
the background will be gray. In the M-480 LAYOUT tab, channels
not being output to the M-480’s REAC B will have a gray
background.
AUX button
If this is on, the post-fader signal will be mixed to the AUX
bus.
Meter
This indicates the input level of the source.
PAN knob
This adjusts the source’s panning in a range of L63–C–R63.
Fader
This adjusts the source’s level in a range of -Inf dB – +10.0 dB.
Group
Shows a group to which a source is assigned.
If a source is not assigned to any groups, that shows "--."
“Source Assign settings” (p. 181)
The function buttons have the following operations:
1.
Access the desired M-48 SETUP popup.
fig.ScrM48Setup.eps
2.
Press [F3 (SOURCE LEV/PAN)].
fig.ScrM48SrcLev1.eps
The M-48 SOURCE LEV/PAN popup will appear.
3.
Verify that the desired M-48 is shown in the target unit
indication.
If the wrong unit is selected, press [F8 (CLOSE)] to close the
popup; then re-select the target and return to step 2.
4.
Use [F1 (SOURCE LAYOUT)] or [F2 (M-480 LAYOUT)] to
select the display that you prefer.
2
1
1
2
2
3
4
5
6
1
1
2
3
4
5
6
[F1 (SOURCE LAYOUT)]
Switches to the SOURCE LAYOUT tab.
[F2 (M-480 LAYOUT)] Switches to the M-480 LAYOUT tab.
[F3 (COPY MIX LEVEL)] Accesses the COPY MIX LEVEL popup, where
you can copy the M-480’s mix levels to
sources (p. 180).
[F5 (SOURCE ON FADER)] If this is on, you’ll be able to use the top panel
faders to adjust the source levels.
[F7 (RESET)] Resets the source level/pan settings (p. 180).
[F8 (CLOSE)] Closes the popup.
Accessing the M-48 SOURCE LEV/PAN
popup
M-480_e.book 179 ページ ２０１１年３月２日 水曜日 午前９時２０分