Roland M-480 - Page 180

180
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
1. Access the desired M-48 SOURCE LEV/PAN popup.
fig.ScrM48SrcLev1.eps
2.
Move the cursor to the faders and pan knobs of sources
1–40, and use the value dial to edit the values.
3.
If you want to use the M-480’s top panel faders to control
the levels, turn [F5 (SOURCE ON FADER)] on.
The display in the M-480 LAYOUT tab will switch in tandem
with the M-480’s channel layer buttons.
1.
Access the desired M-48 SOURCE LEV/PAN popup.
2.
Press [F7 (RESET)].
fig.ScrM48SrcLevClr_Conf.eps
A message will ask you to confirm the operation.
3.
Press [F8 (RESET)] to reset the source level/pan settings
and close the popup.
The parameters of each source will be set to the following
values:
Pressing [F7 (CANCEL)] will cancel the operation.
Here’s how you can copy the M-480’s mix levels (the levels from
channels to MAIN, AUX, or MTX) to the level of the corresponding
source.
1.
Access the desired M-48 SOURCE LEV/PAN popup.
2.
Press [F3 (COPY MIX LEVEL)].
fig.ScrM48CopyMix_Guide.eps
The COPY MIX LEVEL popup will appear.
Mix level select buttons
These select the mix from which the levels will be copied:
AUX1–16, MTX1–8, or MAIN LCR.
If you select MAIN LCR, the sends from AUX to MAIN will also be
included.
Copy PAN (All center on MONO MIX) button
If this is on, the send pan will also be copied.
If you use the mix level select buttons to select a mono mix, the
pan settings will be in the center.
3.
Use the mix level select buttons to select the mix levels
that you want to copy.
If you also want to copy the pan, turn the Copy PAN (All center
on MONO MIX) button on.
4.
Press [F8 (OK)].
fig.ScrM48CopyMix_Conf.eps
A message will ask you to confirm the operation.
In this example, the MAIN L/R mix is being copied.
5.
Press [F8 (COPY)]; the mix levels you selected in step 3
will be copied to the levels of the corresponding sources,
and the popup will close.
Pressing [F7 (CANCEL)] will cancel the operation.
Editing the source level/pan settings
Resetting the source level/pan settings
Parameter
Value
AUX switch
ON
PAN C
LEVEL -Inf dB
Copying the M-480’s mix levels to the
source levels
2
1
1
2
M-480_e.book 180 ページ ２０１１年３月２日 水曜日 午前９時２０分