Roland M-480 - USB MIDI Settings; RS-232 C Settings

112
DCA groups
DCA groups
DCA grouping is a function that lets you make relative adjustments to the output level of channels so that the level of multiple channels
belonging to a group can be controlled together.
fig.DCAGuide.eps
A channel can belong to more than one DCA group. This is convenient when grouping drums or instruments.
The DCA GROUP screen is used to make DCA group settings.
About DCA groups
Faders assigned to DCA DCA Fader
-3 dB offset to each channel
-3 dB
DCA group settings
1.
In the GROUP section, press [DCA].
fig.ScrDCAGroupGuide.eps
The DCA GROUP screen will appear.
DCA group 1–8 faders
These adjust the levels of DCA groups 1–8 in a range of -Inf
dB–+10.0 dB.
The function buttons have the following operations:
When you access the DCA GROUP ASSIGN popup, the [F6
(DCA1–8 ON FADER)] function will be temporarily disabled.
1.
Access the DCA GROUP screen.
2.
Press [F6 (DCA 1–8 ON FADER)] to turn it on.
3.
Use the fader module 1–8 to adjust the level of the DCA
groups.
4.
By pressing [SOLO], you can operate the solo settings of
all channels belonging to the corresponding DCA group.
5.
By pressing [MUTE], you can operate the mute settings of
all channels belonging to the corresponding DCA group.
Accessing the DCA GROUP screen
1
1
[F6 (DCA 1–8
ON FADER)
If this is on, the top panel fader modules 1–8
will control DCA groups.
[F7 (NAME EDIT)] Accesses the NAME EDIT popup (p. 113).
[F8 (ASSIGN)] Accesses the DCA GROUP ASSIGN popup.
Using the panel to control DCA groups
M-480_e.book 112 ページ ２０１１年３月２日 水曜日 午前９時２０分