Roland M-480 - Editing Effect Parameters; Inserting an Effect into a Channel; Accessing the FX EDIT Popup

101
Effects and GEQ
Effects and GEQ
Specifying the effect return channel
1.
Access the EFFECTS screen, and display the FX1–6 tab.
2.
Move the cursor to the FX DESTINATION SELECT popup
button L for FX5, and press [ENTER].
The FX DESTINATION SELECT popup will appear.
3.
Move the cursor to the CH41 button, and press [ENTER]
to select it.
fig.ScrFXOutSel2.eps
If an input port is already patched to the channel, a message
will ask you to confirm the input patching change.
Press [F8 (ASSIGN)] to change the input patching.
If the “PATCHBAY CHANGE” item in the CONFIRMATION section
of User Preference (p. 141) is unselected, no confirmation
message will appear in step 3.
4.
Press [F8 (CLOSE)] to close the popup.
5.
In the same way as you did in steps 1 through 4, select
CH42 as the output-destination for the R side of FX5.
Here we will explain the procedure for inserting the L side of FX1
into CH1.
1.
Access the EFFECTS screen, and display the FX1–6 tab.
2.
Move the cursor to the FX INSERT/SOURCE SELECT popup
button L for FX1, and press [ENTER].
The FX INSERT/SOURCE SELECT popup will appear.
3.
Press [F1 (CH 1–48 INSERT)] to access the CH 1–48 INSERT
tab.
4.
Move the cursor to the CH1 button, and press [ENTER] to
select it.
fig.ScrFXInSel.eps
5.
Press [F8 (CLOSE)] to close the popup.
If you want to insert the effect into both channels of a stereo-linked
pair, make insert settings for both the L and R sides.
Inserting an effect into a channel
Editing effect parameters
The FX EDIT popup is used to edit the effect parameters.
1.
Access the EFFECTS screen, and access the FX1–6 tab.
2.
Move the cursor to the EDIT button for the desired FX,
and press [ENTER].
fig.ScrFxEditGuide.eps
The FX EDIT popup will appear.
Effect parameter field
In this field you can edit the effect parameters. The contents
of this field will depend on the effect type.
The function buttons have the following operations:
You can also make the setting for accessing the popup from a
USER button (p. 140).
Accessing the FX EDIT popup
1
[F1]–[F6]
Switch the display in the effect parameter field.
The number of tabs will depend on the effect
type.
[F6 (TEMPO)] Accesses the TEMPO popup. This exists only for
delay-type effects (p. 103).
[F7 (LIBRARY)] Accesses the FX LIBRARY popup (p. 102).
[F8 (CLOSE)] Closes the popup.
1
M-480_e.book 101 ページ ２０１１年３月２日 水曜日 午前９時２０分