Roland M-480 - Using the Engineers Monitor Function

184
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
Using the Engineer’s Monitor function
By designating an M-48 located beside the engineer as the
Engineer’s Monitor, he/she can monitor and control the mix of
any musician’s M-48 unit from the Engineer’s Monitor.
On the Engineer’s Monitor, you cannot monitor the AUX IN or
the AMBIENT MIC on the musician’s side.
You cannot use the Engineer’s Monitor function if system
program version of the M-48 is prior to 1.01.
1. Access the M-48 MANAGER popup.
fig.ScrM48Manager.eps
1.
In the M-48 list, move the cursor to the desired target
M-48 unit and press [F8 (SET AS ENG MON)].
fig.M48_EngMonConf01.eps
A message will ask you to confirm the operation.
2.
Press [F8 (SET)] to specify the selected M-48 unit as the
Engineer’s Monitor.
fig.M48_EngMon.eps
Pressing [F7 (CANCEL)] will cancel the operation.
3.
To monitor a musician’s mix, select the corresponding M-
48 unit in the M-48 MANAGER popup.
4.
You can also control the musician’s group mix from the
Engineer’s Monitor.
To control the musician’s mix from the Engineer’s Monitor unit,
the MONITOR-ONLY select button on the M-48 ENGINEER’S
MONITOR SETUP popup must be cleared.
The solo function on the M-48 works independently on the
musician’s side and engineer’s side. Therefore, solo operation
on engineer’s side does not affect the musician’s side.
The M-48 unit specified as the Engineer’s Monitor will be
registered to the M-480’s system settings, and it can be saved to
the M-480’s project file. When you initialize the M-480’s system
settings, the Engineer’s Monitor setting will be cleared. You can
load the Engineer’s Monitor settings by loading the system
settings from the M-480’s project file you saved.
The following knobs work independently on the engineer’s side
and musician’s side. The positions of each knob on the
musician’s side are displayed on the M-48 SETUP popup.
• [AUX IN] knob
• [AMBIENT MIC] knob
• LINE OUT [VOLUME] knob
• [BASS] knob and [TREBLE] knob
• [LIMITER] knob
• [PHONES [VOLUME] knob
fig.M48_Setup02_Guide.eps
1.
Access the M-48 MANAGER popup.
2.
Press [F6 (ENG MON SETUP)] to access the M-48
ENGINEER’S MONITOR SETUP popup.
fig.ScrEngMonSetup_Guide.eps
MONITOR-ONLY select button
If this is checked, the Engineer’s Monitor unit works just for
audio monitoring, and it does not control the musician’s mix.
Specifying an Engineer’s Monitor unit
Editing the Engineer’s Monitor
preference settings
1
1
M-480_e.book 184 ページ ２０１１年３月２日 水曜日 午前９時２０分