Roland M-480 - Connecting M-48 Units to the M-480

171
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
LINE OUT
As the LINE OUT source, you can choose PHONES (the signal
immediately before PHONES VOLUME), MAIN bus, or AUX
bus. This is used for a floor monitor or for two-channel
recording. Since a low-pass filter is provided on LINE OUT, it
can also be used to output just the low-frequency range to a
floor monitor or tactile transducer.
The M-48 has 16 memories, and allows mixer settings to be
stored or recalled.
Memories 1–16 can be manipulated from the M-48 itself or from
the M-480.
5
Memory functionality
Connecting M-48 units to the M-480
fig.V-Mix_M48.eps
Use the REAC B port to connect M-48 units to the M-480. A
separately available S-4000D splitter and power distributor is
required in order to connect M-48 units.
The output from the M-480’s REAC B port is distributed via the S-
4000D. Up to sixty-four M-48 units are supported.
The mixing engineer can make settings for each M-48 unit from
the M-480.
If an M-48 unit is connected to the M-480’s REAC A port, it will
not be possible to set or manage the M-48 from the M-480.
Here are some examples of connecting M-48 units to an M-480
that is being used as an FOH console or as a monitor console.
fig.M48ConnectExs-e.eps
REAC B MASTER
SLAVE
S-1608
POWER
POWER POWER
M-480
S-4000D
M-48 M-48 M-48
SPLIT SPLIT SPLIT
Connection examples
Connect M-48 units to the M-480
(setup as the FOH console)
Connect M-48 units to the M-480
(setup as the monitor console)
FOH CONSOLE
S-4000D
SPLIT
M-48 M-48 M-48
SPLIT SPLIT
SLAVE
S-0816
S-4000D
SPLIT
M-48 M-48 M-48
SPLIT SPLIT
FOH CONSOLE
MONITOR CONSOLE
SLAVE
S-1608
S-0808
S-4000M
SLAVE
REAC A
SPLIT MASTER
REAC B
REAC A
MASTER MASTER
REAC B
REAC A
MASTER MASTER
REAC B
M-480_e.book 171 ページ ２０１１年３月２日 水曜日 午前９時２０分