Roland M-480 - REAC Settings

144
REAC applications and settings
REAC applications and settings
REAC settings
The SETUP tab of the REAC CONFIG popup is used to make REAC
settings for the M-480.
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
fig.ScrSystem.eps
2.
Press [F2 (REAC CONFIG)].
fig.ScrSysReacConf1.eps
The REAC CONFIG popup will appear.
3.
Press [F1 (SETUP)].
fig.ScrSysReacConf1Guide.eps
The SETUP tab will appear.
REAC SETUP select buttons
These buttons select REAC settings appropriate for the
desired application.
Setup indication
This area shows the content of the REAC SETUP select
buttons at cursor location, and the types of connections.
4.
Move the cursor to the REAC SETUP select buttons, select
the desired application, and press [ENTER].
You can choose from the following applications:
For details on example connections for various applications,
refer to “REAC connection examples” (p. 143).
5.
Use the setup display area to check the input/output unit
connections, REAC mode settings for the input/output
units, and the signal flow.
For basic knowledge about REAC, refer to “Basic knowledge
about REAC” (p. 13).
For more advanced applications of REAC, refer to “REAC
applications” (p. 142).
2
1
1
2
FOH
Use the M-480 as a FOH (Front Of House)
console. Normally, you should choose this
setting.
MONITOR/
BROADCAST
Use the M-480 as a monitor console or
broadcast console. The REAC outputs from the
FOH console will be received at REAC A.
BACKUP
(S-4000S)
Connect the S-4000S using redundant
connections.
In some cases, a message like the following may appear after
you select MONITOR/BROADCAST A in step 4.
This confirmation message will appear if there is a difference
in sampling frequency between the FOH console (REAC
master) and the MONITOR/BROADCAST console (REAC split).
If you press [F8 (SET)], the cutoff frequency of the MONITOR/
BROADCAST console will be set to match that of the FOH
console.
If you press [F7 (CANCEL)], the current sampling frequency
will be maintained. If you cancel, it will not be possible to
receive the split from the FOH console.
M-480_e.book 144 ページ ２０１１年３月２日 水曜日 午前９時２０分