Roland M-480 - Specifying the Outputs from the M-480 to the M-48 Unit

173
Management of the M-48 live personal mixer
Management of the M-48 live personal mixer
Specifying the outputs from the M-480 to the M-48 unit
Use the REAC B output patchbay to specify the outputs from the
M-480 to the M-48.
1.
In the SETUP section, press [PATCHBAY] to access the
PATCHBAY screen.
fig.ScrPatchbay1.eps
2.
Press [F2 (OUTPUT)] and [F4 (REAC B)] to view the REAC B
output patchbay.
fig.ScrPatchbay2.eps
3.
Use the patchbay grid to select the channels that will be
output to the M-48.
For example, you might make settings as follows:
By using direct out from the PRE EQ or PRE FADER positions, you
can create a mix in which the M-48’s source level/pan settings are
independent of the M-480.
If you use direct out from the POST FADER position, each source will
be output at the level determined by the M-480’s channel fader. In
this case the actual LEVEL setting of the M-48 source is controlled by
the M-480 fader.
In addition to input channel direct outs, you can use a variety of
outputs as sources for the M-48.
• By patching the AUX, MTX, or MAIN outputs you can use
group mixes or the house mix as a source for the M-48.
• By patching TALKBACK you can establish smooth
communication with the musicians.
These output settings are shared by all REAC devices that are
connected to REAC B.
Example) When the S-1608 and M-48 are connected to REAC B
fig.V-Mix_M48_2.eps
• REAC B OUT 1–8 are output from OUTPUT 1–8 of the S-1608.
• Of the 40 sources the M-48 receives via REAC B OUT, sources
1–8 are the same as OUTPUT 1–8 of the S-1608.
REAC B
Channel Purpose
OUT 1–6
AUX1–6 S-1608 stage outputs
OUT 7–8 MAIN L, MAIN R
OUT 9–40 CH1–32 direct out M-48 sources
REAC B
OUT1-40
M-480
S-4000D
S-1608
Output REAC B OUT 1-8Mix REAC B OUT 1-40
M-48
M-480_e.book 173 ページ ２０１１年３月２日 水曜日 午前９時２０分