58
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
Use the PREAMP area to adjust the attenuator.
1.
Use the GAIN dial to adjust the attenuator.
fig.ChEdtPreamp.eps
Use the COMP area to operate the limiter.
fig.ChEdtComp.eps
1.
Press [DISP] of the COMP area to access the LIMITER
popup.
For details, refer to “Limiter operations” (p. 80).
Holding down [SHIFT] and pressing [DISP] for the COMP area
switches the limiter on/off.
Use the PAN area to operate the left/right balance. This is valid for
the MAIN L/R and for stereo-linked AUX/MTX.
fig.ChEdtPan.eps
1.
Use the PAN knob to adjust the balance.
You can make fine adjustments by holding down [SHIFT] while you
operate the knob.
Use the EQUALIZER area to operate the EQ.
fig.ChEdtEQ.eps
1.
Press [ON] to turn the 4-band EQ on/off.
2.
Use the GAIN knob to adjust the gain.
3.
Use the FREQ knob to adjust the frequency.
4.
Use the Q knob to adjust the Q.
You can make fine adjustments by holding down [SHIFT] while you
operate the knob.
By pressing [DISP] you can access the 4-BAND EQ popup, where
you can make detailed settings for the 4-band EQ. For details,
refer to “4-band EQ” (p. 82).
ATT (Attenuator) adjustments
Limiter operations
Adjusting the left/right output balance
4-band EQ operations
M-480_e.book 58 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
