Roland M-480 - Operations in the SCENE Screen

122
Scene memory
Scene memory
Operations in the SCENE screen
The SCENE screen is used to edit the scene list and make various
scene settings.
1.
In the SCENE MEMORY section, press [DISP].
fig.ScrScene_Guide.eps
The SCENE screen will appear.
Scene list
This lists the scenes. The current scene is shown in green.
The list shows the following items:
The RECALL PARAMETERS items are as follows:
The function buttons have the following operations:
1.
Access the SCENE screen.
2.
In the scene list, select the desired scene and press
[F4 (PARAM EDIT)].
fig.ScrRecallParam.eps
The RECALL PARAMETER EDIT popup will appear.
Scene indication
This indicates the scene that will be the object of the RECALL
PARAMETER EDIT popup.
M-48 MEMORY
fig.ScrM48MemRecall_Guide.eps
RECALL button
Add a check mark here if you also want M-48 memory recall
to occur when you recall the scene.
Memory number
This specifies the M-48 memory number that will be recalled
for all connected M-48 units.
RECALL PARAMETERS select buttons
These buttons specify the parameters that will be recalled if
the recall filter is turned on.
Accessing the SCENE screen
Item Explanation
NO.
Scene number.
NAME Scene name.
TIME Date and time at which the scene was
stored.
STATUS If the scene is locked or if the Recall Filter is
turned on, this area will indicate LOCK or
FILT, respectively.
RECALL PARAMETERS A check mark is shown for parameters that
will be recalled as specified by the Recall
Filter settings.
M-48 Indicates the memory number that the M-
48 recalls.
Item
Explanation
IN
Input patchbay settings
OUT Output patchbay settings
PRE Preamp settings
(gain, +48V phantom power, pad)
CH Input channel settings
BUS AUX, MTX, and MAIN L/R settings
FX Effect and external effects device insertion
settings
D/M DCA group and MUTE group settings
REC USB memory recorder settings
TB Talkback and oscillator settings
[F1 (RECALL)] This recalls the mixer parameters from the
currently selected scene number.
1
1
[F2 (STORE)]
This stores the current mixer parameters into
the currently selected scene number.
[F3 (LIST EDIT)] Accesses the SCENE LIST EDIT popup where
you can edit the scene list (p. 124).
[F4 (PARAM EDIT)] Accesses the RECALL PARAMETER EDIT popup
where you can edit the Recall Filter for the
scene selected in the scene list (p. 122).
[F5 (CLEAR)] Clears the contents of the scene selected in the
scene list, making it a blank scene (p. 125).
[F6 (GLOBAL SCOPE)] Accesses the GLOBAL SCOPE popup (p. 125).
[F7 (LOCK)] Locks or unlocks the scene selected in the
scene list.
[F8 (UNDO RECALL)] Undoes (cancels) the last-performed recall.
Using the Recall Filter function
21
3
1
2
21
1
2
3
M-480_e.book 122 ページ ２０１１年３月２日 水曜日 午前９時２０分