Roland M-480 - Saving;Loading S-4000 M Setups

105
Effects and GEQ
Effects and GEQ
Inserting the GEQ
Use the GEQ INSERT SELECT popup to select the destination into
which you want to insert a GEQ.
1.
Access the EFFECTS screen, and display the GEQ 1–8
(GEQ 7–12) tab.
fig.ScrGEQRack.eps
2.
Move the cursor to the GEQ INSERT SELECT popup button
for the desired GEQ, and press [ENTER].
fig.ScrGEQInsSel_Guide.eps
The GEQ INSERT SELECT popup will appear.
Current insert destination indication
This indicates the current insert destination.
Applicable effect indication
This indicates the GEQ to which the GEQ INSERT SELECT
popup applies.
Insert-destination select buttons
Here you can select the insert-destination channel into
which the GEQ will be inserted.
The function buttons have the following operations:
This section describes the procedure for inserting linked GEQ 1
and GEQ 2 into the MAIN L/R.
1.
Access the EFFECTS screen, and display the GEQ 1–8 tab.
fig.ScrGEQRack.eps
2.
Move the cursor to the LINK button at the right of GEQ 1
and GEQ 2, and press [ENTER] to turn the button on.
3.
Move the cursor to the GEQ INSERT SELECT popup button
for GEQ 1, and press [ENTER].
fig.ScrGEQInsSel.eps
The GEQ INSERT SELECT popup will appear.
4.
Move the cursor to the MAIN L insert-destination channel
select button, and press [ENTER] to select it.
5.
Press [F8 (CLOSE)] to close the popup.
6.
In the same way as you did in steps 1 through 5, select
MAIN R as the insert destination for GEQ 2.
Accessing the GEQ INSERT SELECT popup
[F6 (SELECT NONE)]
Clears the input-source selection.
[F8 (CLOSE)] Closes the popup.
21 3
1
2
3
Inserting the GEQ to MAIN L/R
M-480_e.book 105 ページ ２０１１年３月２日 水曜日 午前９時２０分