Roland M-480 - Channel Selection and Layer Operations

31
Explanation of the panels
Explanation of the panels
fig.USBPortGuide.eps
This USB connector can be connected to your PC to control the
M-480 remotely.
For details, refer to “USB MIDI” (p. 152).
fig.LAMPGuide.eps
This is an XLR-4-31 type connector that supplies power to a
commercially available gooseneck lamp.
fig.PinLamp.eps
fig.MIDIPortsGuide.eps
These connectors are for connection with MIDI equipment. An IN
connector (for reception) and an OUT/THRU connector (for
transmission and “thru”) are provided. You can use the REMOTE
popup to switch between the OUT and THRU functions.
For details, refer to “MIDI settings” (p. 153).
fig.SerialSelSWGuide.eps
On the M-480 you can use either the MIDI connectors or the RS-
232C connector. This switch selects the connector(s) you will use.
You must switch off the M-480’s power before changing the
position of this switch.
fig.RS232CPortGuide.eps
You can use this RS-232C connector to remotely control the M-
480 from an external device.
fig.DigiOutJackGuide.eps
These jacks output a consumer format (IEC-60958 compliant)
digital audio signal. Two types are provided: coaxial and optical.
The same digital audio signal is output from both jacks. By
default, MONITOR L/R is patched to these jacks.
fig.TBMicGuide.eps
This is a balanced XLR-3-31 female input jack for connecting a
talkback mic.
922
Wiring diagrams for these jacks are shown below. Make
connections after first checking the wiring diagrams of other
equipment you intend to connect.
fig.XLRJackInput.eps
fig.StereoINGuide.eps
These are RCA phono jacks for inputting analog audio signals
from line level equipment. By default they are patched to CH47
and CH48.
USB connector
LAMP connector
MIDI connectors
RS-232C / MIDI select switch
4
5
GNDNC
NC DC+12V [DC+12V/500mA]
1
2
3
4
6
7
RS-232C connector
DIGITAL OUT jack
TALKBACK MIC IN jack
STEREO IN jacks
8
9
10
+PHANTOM [+48V/14mA]
GND
COLD
HOT
11
M-480_e.book 31 ページ ２０１１年３月２日 水曜日 午前９時２０分