67
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
The function buttons have the following operations:
3.
Move the cursor to the desired copy parameter select
button, and press [ENTER] to select it.
4.
Move the cursor to the desired copy-destination channel
select button, and press [ENTER] to select it. You can
select more than one channel.
5.
Press [F3 (PASTE)].
A confirmation message will ask you to confirm the Copy
operation.
6.
Press [F8 (PASTE)] to execute the Copy operation.
Pressing [F7 (CANCEL)] will cancel the operation.
7.
Press [F8 (CLOSE)] to close the popup.
When you execute PASTE, the copy-destination channel select
buttons will be cleared.
You can recall channel settings from the library, or store the
settings of the current channel in the library.
AUX/MTX/MAIN library operations are performed in the AUX/
MTX/MAIN LIBRARY popup.
1.
Access the CHANNEL DISPLAY screen for the desired
channel.
fig.ScrChAux.eps
2.
Press [F4 (LIBRARY)] to access the AUX/MTX/MAIN
LIBRARY popup.
fig.ScrChLibOutGuide.eps
Target channel
This indicates the channel that is the target of the AUX/MTX/
MAIN LIBRARY popup.
Library data list
This is a list of the library data.
Recall parameter select buttons
Use these to select the parameters that will be recalled. You
can select the following parameters:
[F3 (PASTE)]
Executes the copy.
[F8 (CLOSE)] Closes the popup.
Using the AUX/MTX/MAIN library
ATT
Attenuator
EQ 4-band EQ
Fader Fader
Balance Balance
LCR LCR button, CENTER (AUX only)
Phase Phase
Limiter Limiter
Delay Delay
To MAIN MAIN button, LR button, C button,
PAN (AUX only)
21 3
1
2
3
M-480_e.book 67 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
