Roland M-480 - Page 109

109
Effects and GEQ
Effects and GEQ
4.
Move the cursor to the desired parameter, and use the
value dial to edit the value.
1. Access the GEQ EDIT popup for the desired GEQ.
fig.ScrGEQEdit.eps
If using the 8-band parametric EQ, turn [F6 (analyzer)] on to
display the analyzer.
2.
Use SRC to select the source for the analyzer.
• If you select SELF, the source will be the output of the
channel in which the GEQ is inserted.
• If the analyzer display is too large or too small, use WINDOW
to adjust the vertical display area.
• As desired, use AVG and AVG TIMES to make settings for
averaging.
If an input channel is selected as the source, its direct out will be
the source for the analyzer.
If an output channel is selected as the source, its output will be
the source for the analyzer.
If you want to see the response of the sound that is actually being
produced from the speakers, set up a measurement mic, patch it to
an input channel of the M-480, and select that channel as the
source.
You can recall GEQ settings from the library, and store the current
GEQ settings in the library.
GEQ library operations are performed in the GEQ LIBRARY popup.
1. Access the GEQ EDIT popup for the desired GEQ.
2.
Press [F5 (LIBRARY)].
fig.ScrGEQLibGuide.eps
The GEQ LIBRARY popup will appear.
Applicable GEQ indicator
This indicates the GEQ to which the GEQ LIBRARY popup
applies.
Library data list
This is a list of the library data
The function buttons have the following operations:
For details on library operations, refer to “Library operations” (p.
39).
The GEQ library is shared by GEQ 1–12 and by the GEQ x2 of FX
1–6.
Using the analyzer
If the M-480 and M-480RCS (software that remotely controls
the M-480 from a PC) attempt to display the analyzer
simultaneously, display on the M-480 will take priority. In this
case, the analyzer levels will not be shown in the M-480RCS
window (as shown below).
Using the GEQ library
[F2 (PREVIEW)]
Previews (auditions) the library data that is
selected in the list.
[F3 (NAME EDIT)] Accesses the NAME EDIT popup.
[F4 (RECALL)] Recalls the selected library data.
[F5 (STORE)] Stores the current settings into the selected
library data.
[F6 (CLEAR)] Clears the selected library data.
[F7 (LOCK)] Locks/unlocks the selected library data.
[F8 (CLOSE)] Closes the popup.
1
2
1
2
M-480_e.book 109 ページ ２０１１年３月２日 水曜日 午前９時２０分