147
REAC applications and settings
REAC applications and settings
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
fig.ScrSystem.eps
2.
Press [F2 (REAC CONFIG)].
The REAC CONFIG popup will appear.
3.
Select the target REAC port by pressing [F2 (REAC A)] or
[F3 (REAC B)].
fig.ReacConfig_S4000M.eps
4.
Press [F5 (S-4000M CONFIG)].
fig.S4M_Config1.eps
The S-4000M CONFIGURATION popup will appear.
You can reset and optimize the merge/output patchbays
according to the devices physically connected to REAC ports 1–4.
This has the same function as [AUTO MAP SLAVE UNITS] button
on S-4000M’s front panel.
1.
Access the S-4000M CONFIGURATION popup.
fig.S4M_Config1.eps
2.
Press [F5 (AUTO MAP)].
A confirmation message will ask you to confirm the
operation.
3.
Press [F8 (OK)] to reset the S-4000M Input/Output setups.
Pressing [F7 (CANCEL)] will cancel the operation.
Accessing the S-4000M CONFIGURATION
popup
Resetting S-4000M Input/Output Setups
(System Reset)
M-480_e.book 147 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
