Roland M-480 - Page 158

158
Other settings and functions
Other settings and functions
SENS knob
This adjusts the touch sensitivity of the faders.
2.
Move the cursor to the SENS knob, and use the value dial
to adjust the touch sensitivity of the faders.
If this is set to 0, fader touch sensitivity will be off.
Depending on the environment in which you’re using the M-
480, fader touch sensitivity may not operate correctly, and the
fader motor may operate incorrectly while you’re operating the
fader. If this occurs, use the M-480 with the SENS knob set to 0
so that touch sensitivity is turned off.
1.
Access the SYSTEM screen.
fig.ScrSystem.eps
2.
Press [F1 (INIT)].
fig.ScrInitGuide.eps
The INITIALIZE popup will appear.
Initialize section select buttons
These buttons select the sections to be initialized.
3.
Use the initialize section select buttons to select the
sections that you want to initialize.
You can select the following sections:
SYSTEM SETTING includes the following items:
• The M-480’s sampling frequency setting
• Panel, and display brightness settings
• REAC settings
• Remote settings
4.
Press [F8 (OK)].
fig.ScrInitConf.eps
A message will ask you to confirm the operation.
5. When you press [F8 (INIT)], the section you selected in
step 3 will be initialized.
Pressing [F7 (CANCEL)] will cancel the operation.
Initializing the mixer settings
1
If you turn [TOUCH SELECT] on in the CHANNEL EDIT section,
you’ll be able to select a channel by touching its fader.
If a channel is not selected when you touch its fader, increase
the setting of the SENS knob.
If the faders are too sensitive, turn down the SENS knob.
1
1
MIXER PARAMETER
The mixer parameters will be initialized.
SYSTEM SETTING The system settings will be initialized.
SCENE MEMORY The scene memory will be erased.
ALL LIBRARY All user libraries will be initialized.
USER PREFERENCE The user preferences will be initialized.
If you attempt to initialize the scenes or libraries when a
locked scene or library exists, the following caution message
will appear.
fig.ScrInitLockedCaut.eps
If you press [F6 (DON’T INIT)], the locked data will not be
initialized; only the data that was not locked will be
initialized.
If you press [F7 (CANCEL)], the initialization operation will be
cancelled.
If you press [F8 (INIT)], all data (including the locked data) will
be initialized.
M-480_e.book 158 ページ ２０１１年３月２日 水曜日 午前９時２０分