61
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
For details, refer to “Limiter operations” (p. 80).
Insert indication
fig.ScrChInsOut.eps
FX INS
If FX1–6 are inserted, the number of the inserted FX is shown
here.
If the number is shown in white, the effect insertion is
enabled. If it is shown in gray, effect insertion is bypassed.
By moving the cursor to FX INS and press [ENTER], you can
access the FX 1–6 tab of the EFFECTS.
Inserting an effect into a channel is done in the EFFECTS screen.
For details, refer to “Inserting an effect into a channel” (p. 101).
Up to six effects can be inserted into one channel. In this case,
they will be inserted in series, in order of the FX number.
GEQ INS
If a GEQ is inserted, this shows the number of the GEQ that is
inserted.
If the number is shown in white, the inserted GEQ is enabled.
If it is shown in gray, the inserted GEQ is bypassed.
By moving the cursor to GEQ INS and pressing [ENTER], you
can access the GEQ 1–6 tab or GEQ 7–12 tab of the EFFECTS
screen.
Inserting a GEQ is done in the EFFECTS screen. For details, refer
to “Inserting the GEQ” (p. 105).
EXT FX
If an external effects processor is inserted, this shows the
number of the inserted EXT FX.
By moving the cursor to EXT FX and pressing [ENTER], you
can access the EXT FX 1–6 tab or EXT FX 7–8 tab of the
EFFECTS screen.
Inserting an external effects processor into a channel is done in
the EXTERNAL INSERT screen. For details, refer to “Inserting an
EXT FX into a channel” (p. 111).
4-band EQ
fig.ScrChEQ.eps
EQ button
This turns the 4-band EQ on/off.
4-band EQ graph
This shows the approximate response of the 4-band EQ.
OL (Overload) indicator
This will light when the output of the 4-band EQ exceeds the
OVER Lev setting specified in the METER SETUP popup (p.
96).
Type
These select the filter type from the following choices:
Q knobs
This adjusts the Q in a range of 0.36–16.00. Higher values
produce a sharper curve.
This is not shown when LSV, HPF1, HSV, or LPF1 is selected as
the filter type.
FREQ knobs
This adjusts the frequency in a range of 20 Hz–20.0 kHz.
GAIN knobs
This adjusts the gain in a range of -15.0 dB–+15.0 dB.
This is not shown when HPF1, HPF2, BPF, NOTCH, LPF1, or LPF2
is selected as the filter type.
For details, refer to “4-band EQ” (p. 82).
3
1
2
3
1
2
3
Type
Function Desc.
LSV
Low shelving LO only
HPF1 -6 dB/oct high-pass filter
HPF2 -12 dB/oct high-pass filter
PEAK Peaking
BPF Band-pass filter
NOTCH Notch filter
HSV High shelving HI only
LPF1 -6 dB/oct low-pass filter
LPF2 -12 dB/oct low-pass filter
4
1
2
3
4
5
6
7
1
2
3
4
5
6
7
M-480_e.book 61 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
