Roland M-480 - Mute groups; Mute Group Management and Assignments

71
Dynamics
Dynamics
1. In the fader module section, press a [SEL] button to select
the desired channel.
2.
In the GATE area of the CHANNEL EDIT section, press
[DISP].
fig.PopGate.eps
The GATE/EXPANDER popup will appear.
fig.PopGateGuide.eps
KEY-IN meter
This indicates the level of the key-in signal. For stereo-linked
channels, two meters are shown (L and R).
IN meter
This indicates the input level to the gate/expander. For
stereo-linked channels, two meters are shown (L and R).
GR (Gain Reduction) meter
This indicates the amount of gain reduction produced by the
gate/expander.
Gate/expander graph
This indicates the approximate response of the gate/
expander.
OUT meter
This indicates the output level of the gate/expander. For
stereo-linked channels, two meters are shown (L and R).
TYPE select button
These select the gate/expander type from the following
choices:
Parameters
In this field you can edit the gate/expander parameters.
The contents of this field will depend on the type you select
in the TYPE select button.
Accessing the GATE/EXPANDER popup GATE/EXPANDER popup
GATE
EXPANDER
DUCKING
2
1
3
4 5
9
8
6
7
1
2
3
4
5
6
7
M-480_e.book 71 ページ ２０１１年３月２日 水曜日 午前９時２０分