81
Dynamics
Dynamics
KNEE knob
This adjusts the KNEE in a range of HARD to SOFT1–SOFT9
(ten steps). The way in which the limiter applies to the region
near the threshold level can be adjusted between steep
(HARD) and gradual (SOFT9).
RELEASE knob
This adjusts the RELEASE time in a range of 0 ms–8000 ms.
This is the time from when the signal falls below the
threshold level until the limiter is no longer applied.
When the LIMITER popup is displayed, the limiter can be
adjusted using the EQUALIZER area controls for the CHANNEL
EDIT section.
The function buttons have the following operations:
You can recall limiter settings from the library, or store the
current limiter settings in the library.
The LIMITER LIBRARY popup is used to perform limiter library
operations.
1.
Access the LIMITER popup.
2.
Press [F4 (LIBRARY)] to access the LIMITER LIBRARY
popup.
fig.ScrLmtLibGuide.eps
Channel indication
This indicates the channel to which the GATE/EXPANDER
LIBRARY popup applies.
Library data list
This is a list of the library data.
The function buttons have the following operations:
For details on library operations, refer to “Library operations” (p.
39).
Knob
Parameter
LO MID Q Threshold level
FREQ Attack time
GAIN Release time
HI MID Q -
FREQ Knee
GAIN -
[F1 (LIMITER ON)] Turns the limiter on/off.
[F4 (LIBRARY) Accesses the LIMITER LIBRARY popup.
[F5 (PEAK CLEAR)] Clears the level meter’s peak hold or over
indication.
[F8 (CLOSE)] Closes the popup.
3
4
Using the limiter library
[F2 (PREVIEW)]
Previews (auditions) the library data that is
selected in the list.
[F3 (NAME EDIT)] Accesses the NAME EDIT popup.
[F4 (RECALL)] Recalls the selected library data.
[F5 (STORE)] Stores the current settings into the selected
library data.
[F6 (CLEAR)] Clears the selected library data.
[F7 (LOCK)] Locks/unlocks the selected library data.
[F8 (CLOSE)] Closes the popup.
2
1
1
2
M-480_e.book 81 ページ ２０１１年３月２日 水曜日 午前９時２０分
To Next Page
Loading...
