Roland XC-540 - Page 104

6-7 Correcting Misalignment for Printing or Cutting
102
Chapter 6 Feature Preference
3. Enter the correction values that you read.
Enter the corresponding correction values for H1 through H6.
➊
Press .
➋
Press .
Use
to select. Use to set the correc-
tion value.
Press
to finish making the settings for [SETTING NO.1].
➌
Press .
➍
Press .
Use
to select. Use to set the correc-
tion value.
Press
to finish making the settings for [SETTING NO.2].
➎
Press .
➏
Press .
Use
to select. Use to set the correc-
tion value.
Press
to finish making the settings for [SETTING NO.3].
➐
Press .
➑
Press .
Use
to select. Use to set the correc-
tion value.
Press
to finish making the settings for [SETTING NO.4].
4. Go back to the original screen.
Press .
Press
to go back to the original screen.
Description
This corrects, for each head, the minute misalignment that occurs in the bidirectional-printing mode. When further
correction is required, such as when adjustment made using [SIMPLE SETTING] does not enhance printing, use [DE-
TAIL SETTING] to make corrections for each head.
W 1346mm
SETUP SHEET
ROLL
DETAIL SETTING
SETTING NO.1
DETAIL SETTING
SETTING NO.2
DETAIL SETTING
SETTING NO.3
DETAIL SETTING
SETTING NO.4
H1 H2 H3
000
H4 H5 H6
00 0
H1 H2 H3
000
H4 H5 H6
00 0
H1 H2 H3
000
H4 H5 H6
00 0
H1 H2 H3
000
H4 H5 H6
00 0