1-2 Part Names and Functions
25
Chapter 1 Introduction
Operation Panel
Panel Notation
In this document, the keys and lights on the operation panel are indicated by the following images.
MENU key
SETUP key
ENTER key
Cursor keys
PAUSE key
CLEANING key
TEST PRINT key
TEST CUT key
BASE POINT key
CUT CONFIG key
HEATER CONFIG key
SHEET CUT key
Sub power switch
This switches the printer
on and off. (To switch the
printer off, you hold down
the switch for one second
or longer.) This flashes
slowly when the machine
is in the sleep mode.
Display screen
This displays various set-
ting menus and other in-
formation.
HEATER CONFIG
key
You press this to make the
temperature setting for the
media heating system.
This flashes during warm-
up, then remains steadily
lighted when the preset
temperature is reached.
BASE POINT key
You use this when you
want to set the output-start
location. This lights up
when the setting has been
made.
ENTER key
You use this for such tasks
as enabling setting values.
BUSY light
This lights up during out-
put and other such opera-
tions.
Cursor keys
You use these to select set-
tings for menu items, to
move the media, and for
other such operations.
MENU key
You press this to enter the
menus for various settings.
CUT CONFIG key
This displays the menu for
setting the conditions for
cutting.
TEST CUT key
Holding this down for one
second or longer performs
a cutting test.
CLEANING key
You use this to perform
cleaning of the print
heads.
TEST PRINT key
Holding this down for one
second or longer performs
a printing test.
SHEET CUT key
Holding this down for one
second or longer cuts off
media.
PAUSE key
This pauses output.
SETUP key
You press this when you
load media. This lights up
when media is loaded and
the machine is ready to
perform output.
To Next Page
Loading...
