Roland XC-540 - Accommodating Various Kinds of Media; Adjusting Head Height to Match Media Thickness

85
Chapter 6 Feature Reference
6-4 Accommodating Various Kinds of Media
Adjusting Head Height to Match Media Thickness
Procedure
➊
Press .
Press
several times.
➋
Press .
➌
Open the front cover.
Move the lever to adjust the height of the head.
Moving the lever to "HIGH" makes a warning beep
sound twice. Moving it to "LOW" makes the warning
beep sound once.
➍
Close the front cover.
Press
to enable the setting.
➎
Press .
Press
to go back to the original screen.
Description
Depending on the media, media may wrinkle or come loose from the platen during outputting, increasing the chance
of contact with the print heads. When you are using such media, adjust the head height to "HIGH."
Note that the height of the heads cannot be determined by just the thickness of the media.
Misalignment may occur during bidirectional printing due to the head height or the thickness of the media. If this
happens, perform bidirectional correction to match the media you're using.
☞ P. 100, "Correcting for Misalignment in Bidirectional Printing," p. 101, "Correcting for Misalignment in Bidirectional Printing More Precisely"
Default Setting
[HEAD HEIGHT]: LOW
MENU
HEAD HEIGHT
HEAD HEIGHT
LOW
LOW
HEAD HEIGHT
LOW
HIGH
W 1346mm
SETUP SHEET
ROLL
Height-adjustment lever
Move firmly, until it stops.
High
Low