3-3 Cutting Using the Crop-mark Feature
52
Chapter 3 Using the Cutting Feature
To Stop Detection
➊
Press .
➋
Press .
Detection is stopped.
Aligning Manually and Cutting
Depending on the type of media, it may not be possible to detect crop marks automatically. When crop marks cannot
be detected automatically, you perform alignment manually.
1.
Set the base point.
➊
Use to align the
center of the blade with the location shown in
the figure.
➋
Press .
2.
Set the align points.
➊
Use to align the
center of the blade with the location shown in
the figure.
➋
Hold down for one second or longer.
The number of the align point you set is automatically
determined.
➌
Press .
CANCEL CROPMARK
DETECTION?
W 1200 mm
B
W 1200 mm
B1
SETTING
ALIGN POINT 1
This indicates that the base point
and align point 1 have been set.
To Next Page
Loading...
