36
Chapter 2 Operation
2-3 Settings for the Media Heating System
What Is the Media Heating System?
This machine is equipped with a media heating system that warms the media. You use this mainly to improve ink
adhesion and dry the ink. You can adjust the temperature settings to match the type of media and the printing speed.
WARNING
Caution: high temperatures
The platen and dryer become hot. Exercise caution to avoid fire or burns.
WARNING
Remove any loaded media or switch off the sub power when printing is not being
performed.
The continued application of heat at a single location may cause fire or produce toxic
gases.
WARNING
Never use media that cannot withstand the heat.
Doing so may result in fire or the release of toxic gases, or may degrade the media.
WARNING
Never use the platen or dryer for any purpose for which they are not intended,
such as to dry clothing.
Doing so may cause overheating, resulting in fire or accident.
Making the Temperature Setting for the Media Heating System
Procedure
➊
Press .
The present temperature is displayed.
➋
Press a second time.
Use
to select the unit.
➌
Use to make the setting.
Press
to enable the setting.
➍
Press .
Press
to go back to the original screen.
By default, simply switching on the power does not make the machine warm up to the preset temperature. Pressing
to make the light come on makes the system warm up to the preset temperature.
Dryer
You use this to warm the media after
printing and speed up ink-drying.
Print heater
This device is used mainly to improve
ink adhesion.
Preheater
This device warms the media before
printing.
PRE 35 PRINT 35
DRY 50
DRYER 50
5050
DRYER 50
5550
W 1346mm
SETUP SHEET
ROLL
To Next Page
Loading...
